Electrolux IK2080SR Benutzerinformation Seite 13

Problem
A symbol or symbol
is shown instead of num-
bers on the Temperature
Display.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the tempera-
ture.
The compressor does not
start immediately after
pressing the FastCool, or
after changing the tempera-
ture.
Possible cause
Temperature sensor prob-
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The FastFreeze is switch-
ed on.
The FastCool is switched
on.
The door is not closed
correctly or the gasket is
deformed/dirty.
The water drainage plug
is not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
This is normal, no error
has occurred.
This is normal, no error
has occurred.
ENGLISH
Solution
Contact the nearest Author-
ised Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "FastFreeze func-
tion".
Refer to "FastCool function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" .
The compressor starts after a
period of time.
The compressor starts after a
period of time.
13