Operation; Preparation; Brewing Coffee - Beko CFD6151W Bedienungsanleitung

3

Operation

3.1 Preparation

WARNING: First time use: Run the
A
appliance at least 4 times without
adding coffee.
WARNING: Please follow the steps
A
1 - 2 and 7 - 12 in the "Brewing
Coffee" section.
1. Remove all packaging and stickers and
dispose of them according to applicable legal
regulations.
2. Before using the appliance for the first time,
clean all parts which come into contact with
water carefully. Please see full details in the
"Cleaning and Care" section.
3. Make sure that the appliance is placed in an
upright position and on a stable, flat, clean, dry,
and non-slip surface.

3.2 Brewing Coffee

1. Pull off and fill the water tank (6) with the
required amount of water, but do not fill past
the "10" mark. The brewed amount of coffee
will be 10% less than the filled water, because
it is absorbed by the coffee grounds and the
filter. For the good coffee taste it is suggested
to operate the appliance with at least 4 cups
coffee serving.
C
Use only clean, cold, and fresh
drinking water.
There is a drip hole on the back
of the water reservoir to prevent
C
exceeding the capacity of the coffee
maker. If you add too much water,
it will drip out from the back of the
appliance.
2. Close the water tank cover (1) and open the
filter basket cover (2).
3. Pull out the filter basket (3).
Coffee Maker / User Manual
4. Take a suitable paper filter (1 x 4) and insert the
paper filter into the filter basket (3).
Use only one paper filter at each
C
time. Make sure that the paper filter
does not bend or fold.
5. Fill the filter with the desired amount of ground
coffee. To do this, you may use the supplied
measuring spoon.
6. Insert the filter basket (3) back into the housing.
7. Place the glass jug (8) on the warming plate (9).
WARNING: If the filter basket (3)
is not closed or the glass jug (8) is
A
not placed accurately, the drip-stop
function will not work properly. It
could cause hot water or work hot
coffee to overflow.
8. Connect the plug to the wall socket.
9. Turn the appliance on by pushing the On/Off
button (16).
– The On/Off button (16) illuminates and the
brewing process begins.
The brewing process can be stopped
C
at any time by pushing the On/Off
button (16) again.
Ventilation slots allow the steam
C
output. Do not block these during
use.
The coffee machine has a stay-
warm function and can keep the
brewed coffee warm for up to
C
30 minutes when the machine is
switched on. In accordance with eco
design guidelines, the machine will
automatically switch itself off after
this time.
9 / 89 EN