Non-Return Valve; Battery Power Supply (One Or Two Batteries); Pin Assignment Of Cable - Diehl 171A/B Einbauanleitung

HYDRUS

Non-return valve

ƒ
The meter can be supplied with a non-return valve (accessory) on
request (nominal diameter DN 15 - DN 40).
ƒ
The non-return valve must be mounted in the meter outlet as shown
in fig I for meters with a nominal diameter of DN 15 or fig II for
meters with a nominal diameter for DN 20 and DN 40 or larger.
ƒ
For meters with a nominal diameter of DN 25/32, a compensating ring
must be used to centre the non-return valve. (fig. III).
During the installation, the water meter must be held in this
position (see fig. III) with a suitable tool to prevent damage to
the plastic housing.
4.

Battery power supply (one or two batteries)

ƒ
Standard version with one 3.6 VDC lithium battery with a battery
lifetime of up to 12 years depending on configuration and installation
location.
ƒ
Meter version with two 3.6 VDC lithium batteries with a battery life
time of up to 16 years depending on configuration and installation
location.
Batteries cannot be retrofitted or replaced!
5.

Pin assignment of cable

The M-Bus, L-Bus or pulse variant of the meter is supplied with a 1.5-m
long 3-wire cable with wire end ferrules.
Power supply takes place via the internal battery. An external
power supply via a M-Bus Master is not possible.
-16-
Deutsch
English
Français Português