Install The Hardware - Axis M1145 Installationsanleitung

Install the Hardware

1. Attach the stand to the camera by screwing it on. For wall
mounting, attach the stand to wall first, using 3 appropriate
screws.
2. Attach the network cable to the network connector on the
camera unit.
3. Check that the indicator LEDs indicate the correct conditions.
See LED Indicators on page 11.
Note
Make sure the light sensor is not covered. This could affect its
performance and lead to false day/night shifts.
Set focus and zoom
1. Go to Video > Focus & Zoom.
2. On the Basic tab, set the zoom level using the slider.
Click the < or > button to move the zoom position one step.
Click the << or >> button to move the zoom position in
multiple steps.
Note
Movements in front of the camera should be avoided when
performing autofocus.
3. Click Perform autofocus.
4. If the autofocus was not satisfying, go to the Advanced tab.
On the Advanced tab, focus can be adjusted manually:
1. Click Open iris to open the iris to its maximum position.
This gives the smallest depth of field and provides the best
conditions for focusing.
2. Focus is set in the Focus window. Use the mouse to move
and resize the focus window.
3. Click in the Focus position bar to focus on a desired location.
AXIS M1145 Series
17