Koenic KDW 60121 A2 BI Gebrauchsanweisung Seite 22

English
Installation
Fig. The dishwasher must be installed in
1
sufficient proximity of water, sewage
and electrical connection.
Caution
After unpacking open the door and remove
all transport protections from the baskets
and spray arms. Ensure that the spray arms
can rotate freely.
Note:
Please check the included mounting material,
brackets, screws and Velcro strip for attaching
the decorative panel, etc.
Observe the installation dimensions.
1
• A location near the sink is recommended
to allow for an easier connection of
the dishwasher to water and sewage
connections
• At the back of one or both lateral
cupboards, recesses of size 80 x 100 mm
must be fitted for water, sewage and
electrical connection (A).
If the dishwasher is installed in a corner, a
2
minimum clearance of 50 mm between the
opened door and surrounding cabinets must
be respected.
Note the dimensions, holes and cutouts of
3
the decorative plate.
Pull apart the supplied Velcro strips and
4
remove the protective strips. Stick the 4
Velcro strips in the recesses of the door and
the decorative plate. Align the decor panel
and attach it to the door of the dishwasher.
Remove the 4 lower screws.
5
Screw the supplied 4 long screws through
6
the door and fasten the decorative plate.
22
IM_KDW 60121 A2 BI_170711_V04_HR.indb 22
The springs of the dishwasher door were
7
set correctly at the factory.
• After installation of the decorative plate,
the spring force of the door may have to
be adjusted.
• Twist the adjusting screws on both sides
to increase/decrease the spring force.
Please refer to the illustration next to
the screws.
• The spring force is adjusted correctly
when the fully opened door remains in a
horizontal position and can be moved up
all the way by slightly pulling on it.
Fasten the condensation strip below the
8
worktop. Make sure that it closes with the
front edge of the countertop.
The dishwasher must be connected to
9
drainage.
1. The hose is already connected to the
waste water outlet. Cut the straps and
unwind the hose.
2. Connect the end to a drainpipe (Option
A or B). Consider the max. height of the
outlet of drainage hose.
:
Note
A suitable hose holder is available as optional
accessories.
Connect the water inlet to tap water supply
10
(3/4") using the pre-assembled hose and
make sure it is fastened tightly.
Note:
If the water pipes are new or have not been
used for an extended period of time, let the
water run to make sure that the water is
clear and free of impurities. If this precaution
is not taken, there is a risk that the water
inlet can get blocked and damage the
appliance.
11/7/17 8:47 am