Ecler DAM614 Bedienungsanleitung Seite 18

Pressing SHIFT + EXIT at any point during the above process cancels the selection and returns
the main screen.
If the selection is validated (SHIFT + SAVE) the following screen is displayed, allowing you to
rename the destination preset:
[ P 0 7 ] S T E R E O
To rename the preset:

Edit the first character with an encoder (ZA or ZB)

Press PARAMETER to select the next character to edit

Select the new character with an encoder

Etc...

Pressing SHIFT + CANCEL cancels the previous changes and the display returns to the
original state

Once all the desired characters are edited, confirm the changes by pressing SHIFT +
SAVE, displaying the PRESET SAVED message for a few seconds. The preset is stored
in memory, but is not selected as active preset by the fact of having been saved

The main screen returns, showing again the current preset at the time, and it is not
necessarily the newly saved preset
Pressing SHIFT + EXIT at any point during the above process cancels the selection and returns
the main screen.
The parameters stored in a preset are:

All the input and output settings, including their names (labels)

The setup for REMOTE ports 1, 2, 3 and 4 and the MUTE port (allowing to mute outputs
via an external contact closure)
18
R E N A M E P R E S E T
L I V E 3 W