Start-Up; Inserting The Batteries In The Remote Control; Placing A Television Or Monitor Onto The Soundbase; Connecting Audio Equipment - Medion LIFE P64633 Bedienungsanleitung

6. Start-up

6.1. Inserting the batteries in the remote control

The remote control is operated with two 1.5-V AAA batteries.
If the product fails to respond or is slow to respond to the remote control, you will
need to change the batteries. Proceed as follows:
 Pull the opening tab on the battery compartment
upwards and remove the battery compartment cover.
 Insert 2 x 1.5-V AAA batteries so that the negative end
is placed next to the springs. Refer to the diagram in
the battery compartment.
 Place the battery compartment cover with the locking
tab onto the opening in the battery compartment, and
press the cover downwards until it audibly clicks into
place.
ATTENTION
Risk of explosion if batteries are replaced incorrectly.
Replace batteries only with the same or equivalent type.
6.2. Placing a television or monitor onto the
soundbase
Televisions or monitors that weigh up to 45 kg
and have a fixed base can be placed on top of
the soundbase. Devices with narrow feet are
not suitable, as the weight of the device is not
evenly distributed and this can cause damage
to the soundbase.
 Place the television or monitor with the
base in the middle of the soundbase.

6.3. Connecting audio equipment

• Observe the instructions in section "3. Safety information" on page 85 ff.
• Also comply with the operating instructions of the device to which you want to
connect the soundbase.
• Switch off all devices before connecting them to each other.
You can connect a number of different audio devices to this product, e.g. an MP3
player, a CD player, the receiver of your stereo system, a computer or even your
television.
DE
FR
NL
DK
EN
93 of 102