Maintenance - Makita GD0800C Betriebsanleitung

Speed adjusting dial (Fig. 4)
The tool speed can be infinitely adjusted by turning the
speed adjusting dial, which is marked 1 to 5. Higher
speed is obtained when the dial is turned in the direction
of number 5; lower speed is obtained when it is turned in
the direction of number 1.
Refer to the table below for the relationship between the
number settings on the adjusting dial and the approx. tool
speed.
GD0800C
-1
Number min (RPM)
1 – 2 7,000 – 10,000
2 – 3 10,000 – 17,000
3 – 4 17,000 – 24,000
4 – 5 24,000 – 28,000
CAUTION:
• If the tool is operated continuously at low speeds for a
long time, the motor will get overloaded and heated up.
• The speed adjusting dial can be turned only as far as 5
and back to 1. Do not force it past 5 or 1, or the speed
adjusting function may no longer work.
Operation (Fig.5)
Turn the tool on without the wheel point making any con-
tact with the workpiece and wait until the wheel point
attains full speed. Then apply the wheel point to the
workpiece gently. To obtain a good finish, move the tool
in the leftward direction slowly.
CAUTION:
• Apply light pressure on the tool. Excessive pressure on
the tool will only cause a poor finish and overloading of
the motor.
6

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by a Makita
Authorized Service Center.
GD0810C
-1
min (RPM)
1,800 – 2,400
2,400 – 4,100
4,100 – 5,800
5,800 – 7,000