Equalizer Settings - Onkyo TX-NR474 Bedienungsanleitung

> Before Start > Part Names
AccuReflex You can enhance the reflection effect of Dolby enabled speaker
from the ceiling.
"On": When this function is to be used
"Off (default value)": When this function is not to be used
0 The function is not effective if the listening mode is Pure Audio
or Direct.
0 This setting can only be selected when you have set "Configuration" - "Height Speaker" to
"Dolby Speaker".
∫ 6. Equalizer Settings
You can adjust the output volume of the range of each connected speaker. You can adjust
the volume of the different sound ranges for each of the speakers. You can set three
different equalizers in Preset 1 to 3. You can select up to five bands for the Subwoofer and
nine bands for all other speakers. To use the set equalizer effects, select the preset number
in "Quick Menu" - "AccuEQ" - "Equalizer"(P66).
Front After selecting the speaker frequency from between "25 Hz" and
"16 kHz" with the cursors
frequency between "-6.0 dB" and "+6.0 dB" with
Value is "0.0 dB")
Center After selecting the speaker frequency from between "25 Hz" and
"16 kHz" with the cursors
frequency between "-6.0 dB" and "+6.0 dB" with
Value is "0.0 dB")
Height After selecting the speaker frequency from between "25 Hz" and
"16 kHz" with the cursors
frequency between "-6.0 dB" and "+6.0 dB" with
Value is "0.0 dB")
Surround After selecting the speaker frequency from between "25 Hz" and
"16 kHz" with the cursors
frequency between "-6.0 dB" and "+6.0 dB" with
Value is "0.0 dB")
> Install > Initial Setup
/ , adjust the volume of that
/ . (Default
/ , adjust the volume of that
/ . (Default
/ , adjust the volume of that
/ . (Default
/ , adjust the volume of that
/ . (Default
> Playback
Advanced Setup
Subwoofer After selecting the speaker frequency from between "25 Hz" and
"160 Hz" with the cursors
frequency between "-6.0 dB" and "+6.0 dB" with
Value is "0.0 dB")
0 This cannot be selected if "No" is set in "Configuration" -
"Subwoofer".
0 The result may not be as expected depending on the input source and listening mode
setting.
3. Audio Adjust
∫ 1. Multiplex/Mono
Multiplex Input Set the audio channel or language to be output when playing
Channel multiplex audio or multilingual TV broadcasts etc.
"Main (default value)": Main channel only
"Sub": Sub channel only
"Main / Sub": Main and sub channels will be output at the same
time.
0 If multiplex audio is being played, "1+1" will be displayed
when on the remote controller is pressed.
Mono Input Channel Set the input channel to use for playing any 2 channel digital
source such as Dolby Digital, or analog/PCM source in the Mono
listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right (default value)" : Left and right channels
∫ 2. Dolby
Loudness When playing Dolby TrueHD, enable the dialog normalization
Management function which keeps the volume of dialog at a certain level. Note
that when this setting is Off while playing Dolby Digital Plus/
Dolby TrueHD, the Late Night function that allows you to enjoy
surround at low volumes is fixed to Off.
"On (default value)": When this function is to be used
"Off": When this function is not to be used
| Supplementary Information | Others
/ , adjust the volume of that
/ . (Default
57
En