Onkyo TX-NR474 Bedienungsanleitung Seite 5

> Before Start > Part Names
16.LISTENING MODE buttons: Select listening modes
(P35).
17.SETUP MIC jacks: Connect the supplied speaker
setup microphone.
18.AUX INPUT jacks:
Connect a video camera, etc., using a stereo mini plug
cable (Ø 1/8z/3.5 mm).
> Install > Initial Setup
 

Display
1. Speaker/Channel display: Displays the output channel that
corresponds to the selected listening mode.
2. Lights in the following conditions.
Ë: When headphones are connected
: When connected via BLUETOOTH
: When connected by Wi-Fi
NET: When "NET" is selected with the input selector and the unit is
connected to the network. It will flash if the connection to the network is
not correct.
USB: When "NET" is selected with the input selector and the unit is
connected by USB and the USB device is selected. Flashes if the USB
is not properly connected.
HDMI: HDMI signals are input and the HDMI input selector is selected.
DIGITAL: Digital signals are input and the digital input selector is
selected.
3. Lights according to the type of input digital audio signals and the
listening mode.
4. Lights in the following conditions.
RDS: Receiving RDS broadcasting.
TUNED: Receiving AM/FM radio.
FM ST: Receiving FM stereo.
SLEEP: Sleep timer has been set.
AUTO STBY: Auto Standby has been set.
5. Flashes when muting is on.
6. Displays various information of the input signals.
7. This may light when performing operations with the "NET" input
selector.
> Playback
Advanced Setup | Supplementary Information | Others
  
 
5
En