Calpeda EASYMAT Originalbetriebsanleitung Seite 24

9.2.1. UP – User settings
N° Description
UP01 restart mode power failure
[rA = automatic; rM = manual]
UP02 Nominal pump current
UP03 Nominal pump frequency
UP04 Direction of rotation
[ --- = std rotation; --- = inverted rotation]
UP05 Set point pressure
9.2.2. AP – Advanced settings
To enter password is required (see paragraph 10.1.)
N° Description
AP01 Pressure transducer set-up
[sensor full-scale]
AP02 Ramp down
AP03 Ramp-up
(fixed value for MM)
AP04 Time before stop
AP05 Dry-run time
AP06 First dry-run time
AP07 Dry-run pressure
AP08 System dynamic
[1 = fast dynamic; 5 = slow dynamic]
AP09 Cascade mode
[oFF; UU = cascade mode with double inverter;
dP = Twin pump
UF = cascade mode with an inverter]
AP10 Master/Slave setting
MAS = master; SLA = slave
AP11 Reset to factory set-up
AP12 Digital input activation
[0 = oFF; 1 = no; 2 = nC]
AP13 Digital output activation
[0 = oFF; 1 = on; 2 = no; 3 = nC]
AP14 Restart fall pressure set-up
AP15 Pump address
AP16 Cascade mode start fall pressure set-up (bar)
AP17 Cascade mode restart delay
AP18 Cascade mode fall pressure limit set-up (bar)
AP19 Digital input delay time
[float switch delay time]
24
Standard Modifications Note
rA
(A) 0,1
(Hz) 50
---
(bar) 1,5
Standard Modifications Note
(bar) 10
(s) 3
(s) 2 MT
0 MM
(s) 30
(s) 10
(s) 60
(bar) 1,5
3
oFF
SLA
1
0
(bar)
SLA1
0,3
(s) 10
0,6
(s) 30
4.93.410