Operating Times; Operating - Wolf Garten RQ 745 Gebrauchsanweisung

Safety instructions
• Keep your hands away from the moving cord.
• Wear eye protection!
• Always wear appropriate working clothes and sound footwear when using the trimmer.
• Before carrying the trimmer to the next lawn area to be cut, switch it off.
• Be careful when you go backwards. You may stumble!
• Keep the cable away from the cutting tool.
• Should the powercord be damaged during use, immediately disconnect it from the mains. Do not touch the
cable until it has been disconnected from the mains.
• Never leave the trimmer without supervision. Store it in a safe place.
• The switches installed shall not be removed or bridged over, e. g. by binding the switch to the handle.
• Do not allow the cord spool to strike the ground or edges of working area. If the cord spool receives a hard knock, this
will cause a strong vibration on the handle. If this occurs, the trimmer should be checked by a qualified service centre.
5. After operating
• After using the unit, disconnected the power cord from the wall outlet and inspect the unit for damage.
• When switching off the trimmer: Attention: the cutting tool does not stop immediately!
• Always wait for the cutting tool is stop.
• Before examining or cleaning the tool or before removing the safety device or the cord spool, switch off and
disconnect the trimmer from the mains. Only use original WOLF cord spools and note the installation instructions!
• The cutting knife should not be cleaned under running water or under high-pressure.
• Faults shall only be repaired by appointed service centres or by the manufacturer.
• Make sure all air holes are free of dirt.
• Do not store the unit within reach of children.

Operating times

Please convider the individual country spezification.
Operation
How to adjust the central handle (fig. B1)
The central handle may be adjusted individually depending on the height of the user.
Recommendation: 20 cm from the upper handle.
1. Open the quick-fixing device.
2. Slide the central handle to your working position.
3. Tighten the quick-fixing device.
Mounting the extension cable (fig. B2)
See illustration
Connection to power source
Alternating current, 230 V, 50 Hz. The tool can be connected to any mainssocket.
Attention!
To connect tool to mains use only approved extension cable (HO7 RN-F3 G1.0).
Adjust main shaft angle (fig. B3)
• Use foot switch to adjust main shaft angle.
• Five positions are possible (Upper position = park position).
Working position
For edge cutting and free cutting approx set shaft angle to middle position (30°).
Free cutting (fig. B4)
For free cutting (no ground contact) swing device in a semicircle before your body.
Vertical trimming (fig. B5)
For trimming of lawn edges.
1. Turn the middle handle by 180°
2. Set shaft angle to lowest position.
11