Troubleshooting - Medion P89400 Bedienungsanleitung

Troubleshooting

Problem
No response after in-
teraction with the base
station
Not possible to connect
the accessory with the
base station
108 of 168
Cause of the error
The base station is
switched off
Power cut
Backup batteries are
flat
The base station is not
in connection mode
Accessories have not
been triggered for
connection
When attempting the
connection, the base
station emits two beeps
Solution
Open the battery
compartment and
switch the device on
Check your electricity
supply
Plug the mains adapt-
er into a wall socket
The accessory
has already been
connected
When connecting
an accessory to the
base station, it is only
permitted to trigger
one accessory at a
time (i.e. you must
leave the detection
area of a motion sen-
sor that is not to be
connected)
You can find instruc-
tions for connecting
the remote control
to the base station in
this manual