rotor Vitamat Inox RVI Reparaturanleitung Seite 11

2.2 Replace the electronic board SMD
a
Correct wiring of the safety switches is very important for the
safety of user. Old units need replacement of the safety switches.
Art.Nr. Bezeichnung
1120.930 GT Spezial Gabelschlüssel SW8
Reparaturanleitung / Repair instructions
Rotor Vitamat Inox RVI
Dismounting the electronic board SMD
Mounting the electronic board SMD
Warning! Spare part
with safety function!
- Remove base plate.
- Place the special fork wrench
(1120.930) between the commutator
and frame over the milled faces of the
motor shaft.
- Loose the hexagonal nut over the fan
with a wrench (size 11mm), turn to right
(clockwise). Attention left-threaded!
- Remove the fan and the electronic board
SMD (Torx 10).
- Component is fitted in the reverse
sequence to removal.
- Test of correct function, especially all
safety functions! no rotating if li dis open
or without Container! Check correct
earthing!
Designation
GT special spanner AF8
REP-RVI-1210-1-DE-EN
St/
Qte
1
11