Adjustments - Pattfield PE-240SS Bedienungsanleitung

SANDING PAPER / VELCRO
1 Remove any dust or debris from the
sanding pad 5.
Caution! Make sure the tool is
switched off and unplugged.
3 To remove the sanding paper carefully
peel it off the sanding pad 5.
Do not use the same sanding paper
for metal and wood.
SANDING ROLL / CLIPS
1 Remove any dust or debris from the
sanding pad 5 and open the sandpaper
clip 9 at the front of the tool.
Caution! Make sure the tool is
switched off and unplugged.
3 Turn the tool around and open the
sandpaper clip 9 at the rear of the tool.
SPEED SETTING
1 Use speed dial 4 to set the operation
speed.
Caution! Make sure not to cover the
ventilation slots during operation.
2 Use a velcro sanding paper of 190 x
93 mm. Align the holes in the sand-
ing paper with the ones in the sanding
pad 5 and press the sanding paper into
place.
2 Use a 93 mm wide sanding roll and cut
it to a length of 240 mm.
Place the sanding paper centric on the
sanding pad 5. Fold the sanding paper
under the sandpaper
4 Fold the sanding paper under the sand-
paper clip 9 and close it.
Do not use the same sanding paper
for metal and wood.
2 The operation speed can be set in sev-
en steps from:
1 = 6000/min - MAX = 11000/min
clip 9 and close it.
EN 87