Adjustments; Noise & Vibration - Pattfield PE-430ES Bedienungsanleitung

SANDING PAPER
1 Remove any dust or debris from the
sanding pad 3.
Caution! Make sure the tool is
switched off and unplugged.
3 To remove the sanding paper carefully
peel it off the sanding pad 3.
Do not use the same sanding paper
for metal and wood.
SPEED SETTING
1 Use speed dial 2
speed.
Caution! Make sure not to cover the
ventilation slots during operation.
Noise & Vibration
The values given in these instructions have
been measured in accordance with a stand-
ardized measurement procedure specified in
EN 60745 and can be used to compare tools.
It may be used for a preliminary assessment
of exposure. The declared vibration data rep-
resents the main applications of the tool, but
different uses of the tool or poor maintenance
can result in different vibration data. This may
significantly increase the vibration level over
the total working period.
An estimation of the vibration level should
also take into account the intervening periods,
when the tool is switched off or it running but
is not actually in use. This can result in a much
to set the operation
lower vibration load over the whole working
period.
Additional safety measure can be taken to
protect the user from effects of vibration:
Maintain the tool and its accessories, keep the
hands warm and organize work patterns.
2 Align the holes in the sanding paper
with the ones in the sanding
press the sanding paper into place.
Choose the correct grain size from the
table below:
OPERATION
Removal
Preparation
Finish
2 The operation speed can be set in six
steps from:
1 = 8000/min - MAX = 13000/min
pad 3 and
GRAIN SIZE
40 - 60
80 - 120
180 - 240
EN 87