Balluff MICROPULSE+ BTL7-A504-Series Handbuch Seite 22

BTL7-A/C/E/G501/504/505-... / BTL7-C/E508/509/512/513-...
Micropulse Configuration Tool
3
Windows and tabs (continued)
3.2.3 Transducer information
The following transducer information is displayed:
– Type
– Serial number
– Firmware version
– Nominal length of the connected transducer
– Output type: Voltage or current
3.2.4 Connection
This symbol is displayed when the communication
box is active.
Transducer is connected.
Transducer is not connected.
3.2.5 Menu bar
The menu bar contains the menu commands. The menu
commands are described in Section 4 "Menus" starting on
page 12.
3.2.6 Update transducer
Uncontrolled system movement
When starting up, if the position measuring system is part
of a closed loop system whose parameters have not yet
been set, the system may perform uncontrolled
movements. This could result in personal injury and
equipment damage.
► The system must be taken out of operation before
configuration.
► Transducers may only be connected to the
communication box for configuration.
► The communication box must be removed after
configuration.
Changed values for a configuration are displayed in the
Micropulse Configuration Tool by means of blue numbers
and letters and the U
pdate transdUcer
Clicking on U
pdate transdUcer
transducer. Transmission takes a certain amount of time,
since all the parameters are sent.
The U
pdate transdUcer
there are changed settings pending.
8 english
DANGER
button is active.
sends the information to the
button is only active if
3.2.7 Tabs
Settings are made on the tabs.
Magnet:
– Select number of magnets.
– Online display of the configuration
Output 1:
Select the function and set the characteristic curve.
Output 2:
Select the function and set the characteristic curve. The
tab is only shown if the connected transducer has two
outputs (depends on style).
The following sections describe the tab elements and how
to make or change settings.