Before Switching On; Door Height Adjustment - Nabo SBS 4900 Handbuch

Before Switching On

•Before using your appliance, add a teaspoon of bicarbonate of soda to warm
water and with a damp cloth wipe down all parts of the new appliance, then
repeat the process with a clean damp cloth and dry(ensure the appliance is not
connected to the power when performing this task).
•Remove all transport tapes and foam protection pieces . Clean the interior with
a cloth dampened in lukewarm soap and water. Wipe with clean water and wipe
dry.
•There may be an odour when you first switch on the appliance, it will disappear
when the appliance starts to cool.
•When the appliance has been positioned, adjust the feet to ensure the unit is
stable. This is essential to ensure quiet running and proper door opening /
closing.
•Connect to the electrical socket but do not switch the power to the refrigerator
on for at least 3 hours. The coolant within the product needs time to settle after
it has been transported and put in to position, failure to do this will affect the
cooling performance of your appliance.
•Once the appliance has settled switch on the power, the compressor will begin
to work. Locate the control panel and set the temperature of the fridge
compartment to 4°C and the freezer compartment to -18°C. Close the door
•You may hear faint gurgling or bubbling sounds when the refrigerant is pumped
to the cooling system and through the coils or tubing at the rear of the appliance.
When the compressor is in operation you may hear a slight whirring sound or
pulsating noise. The thermostat controls the operation of the compressor, and
you may hear a slight click as it cycles in and out (this is normal).
•To save energy, you should minimize the frequency and duration of door opening.

Door Height Adjustment

If the doors of the appliance are not aligned then the height of them can be
adjusted, if required please follow the below steps.
Note: The maximum height adjustment is 5mm
Rotate the locking nut clockwise (as shown in the diagram below) with a wrench
for 2 full rotations to loosen it. You can now rotate the adjusting nut(as shown in
diagram below) to raise or lower the height of the door. Once the door is set to
your desired position, then tighten the locking nut by rotating it anti-clockwise.
Adjusting nut
Left
Locking nut
003