Specifications - IMG STAGELINE MPX-1 serie Bedienungsanleitung

5.1 Mixing of the connected audio sources
1) Adjust the volume of the input channels CH 1 and
CH 2 with the faders (9) and the volume of the DJ
microphone connected to the jack (10) with the DJ
MIC control (7). The stereo output level is displayed
by the 7-step LED level display (1). At 0 dB the
mixer is at its rated maximum output. Overloads are
indicated via the level display by lighting of the red
LEDs.
The faders of the channels CH 1 and CH 2 should
2
be at approx. / of the maximum after the level ad-
3
justment so that there is sufficient control range for
fading in and out. If the faders are almost at mini-
mum or maximum position, the levels have to be
matched by adjusting the input amplification: Turn
up resp. turn back the GAIN controls (4) correspond-
ingly.
2) Adjust the desired sound characteristic for channels
CH 1 and CH 2 with the TREBLE controls (5) and
the BASS controls (6): The high and low frequen-
cies can be increased resp. decreased by 12 dB.
The frequency response is not affected if the con-
trols are in center position.
3) Fading between the channels CH 1 and CH 2 is
possible via the crossfader (12). If the crossfader is
in center position, both channels are fed to the out-
puts simultaneously.
5.2 Monitoring of the channels
Via the monitoring function it is possible to monitor the
input channels CH 1 and CH 2 individually by head-
phones. The level of the monitored signal is indepen-
dent of the setting of the corresponding channel fader.
By monitoring of an input channel the best moment for
fading in the corresponding audio source can be se-
lected.
1) Connect stereo headphones (impedance ≥ 8 Ω) to
the PHONES jack (14).
2) Select the channel CH 1 or CH 2 with the selector
switch PFL ASSIGN (11).
3) Adjust the desired headphones volume with the
PFL control (8).
Caution! Do not adjust the headphones to a high
volume. Permanent high volumes may
damage a person´s hearing! The hu-
man ear gets accustomed to high vol-
umes which do not seem to be that high
after some time. Therefore, do not fur-
ther increase a high volume after get-
ting used to it.
5.3 Annoucements via the DJ microphone
For better intelligibility of a microphone announce-
ment, the levels of the channels CH 1 and CH 2 can be
decreased by 16 dB. Adjust the TALKOVER switch
(13) to position ON.
The talkover function is deactivated in the OFF
position.

6 Specifications

Inputs
1 x mic, mono: . . . . . . . . . . . 1.5 mV/ 600 Ω
2 x phono, stereo: . . . . . . . . 3 mV/50 kΩ
2 x line, stereo: . . . . . . . . . . 150 mV/50 kΩ
Outputs
1 x amp: . . . . . . . . . . . . . . . . 1 V/600 Ω
1 x record: . . . . . . . . . . . . . . 0.5 V/600 Ω
General
Frequency range:. . . . . . . . . 20-20 000 Hz
THD: . . . . . . . . . . . . . . . . . . 0.1 %
S/N ratio
Line: . . . . . . . . . . . . . . . . . 61 dB
Phono: . . . . . . . . . . . . . . . 56 dB
Mic: . . . . . . . . . . . . . . . . . 49 dB
Equalizer
2 x bass: . . . . . . . . . . . . . ±12 dB/50 Hz
2 x treble: . . . . . . . . . . . . . ±12 dB/10 kHz
Talkover: . . . . . . . . . . . . . . . -16 dB
Headphones output: . . . . . . ≥ 8 Ω, stereo
Power supply: . . . . . . . . . . . 12 V~/600 mA
Permissible
operating temperature: . . . . 0-40 °C
Dimensions (W x H x D): . . . 164 x 77 x 218 mm
Weight:. . . . . . . . . . . . . . . . . 1.2 kg
Connections
Mic: . . . . . . . . . . . . . . . . . . . 1 x 6.3 mm (
Headphones: . . . . . . . . . . . . 1 x 6.3 mm (
All other audio connections:. 12 x phono
Power supply: . . . . . . . . . . . 3.5 mm jack
According to the manufacturer.
Subject to change.
via supplied plug-in
transformer
(230 V~/50 Hz/10 VA)
1
/ ") jack
4
1
/ ") jack
4
GB
7