Cleaning And Maintenance; Technical Data - ECG KG 300 deluxe Bedienungsanleitung

Use as a contact grill or panini press
1. Make sure that the drip tray is properly inserted in the appliance.
2. Make sure that the grilling plates are properly set and secured.
3. Place the grill on a fl at, dry surface, unwind the power cable fully and
insert the plug of the power cable in the electrical outlet.
4. Using the thermostat control, set the required temperature an let the
grill to warm up. Once the grill heats up to the set temperature, green
indicator light comes on.
5. Opening the grill:
• Check if the grill is heated to the required temperature (green indicator is on).
• Make sure that the upper grilling plate is properly secured. The adjustable latch 4 on the right side of
the upper plate has to be in the "OPEN" position.
• Use the handle to open the lid with the upper plate in 105 degrees position.
• Place food on the bottom grilling plate.
6. Using the handle, close the upper plate.
7. The top grilling plate off ers two features for reaching optimum results:
• Floating upper plate. The upper plate is hinged so that it can rest on the grilled foods in horizontal
GB
position. This ensures that the top of the food would be cooked as evenly as its bottom part. This
system also allows the plate to fl oat freely over the food, radiating heat. This way can be also made e. g.
open sandwiches with melted cheese on top.
• Adjustable height. This feature reduces the weight of the upper plate resting on fi ne foods, like e. g.
fi sh, and enables adjustment of its height to various foods, like e. g. home made bread. On the right
side of the upper plate is the adjustable latch 4, that is used to fi x the upper plate in several diff erent
heights from the bottom plate. To set the desired height, lift the upper plate using the handle and in
the same time move the adjustable latch in the required height position. Then gently lower the upper
plate until it leans on the adjustable latch.
8. When the food is cooked, remove it from the plates using wooden or heast-resistant plastic utensils.

CLEANING AND MAINTENANCE

• Unplug the appliance from the power supply and wait until the appliance and the plates cool thoroughly
before cleaning.
• Clean the external surfaces with only moistened cloth to prevent water, oil or grease from getting into the
appliance.
• Remove and empty the drip tray after each use. Then wash it with hot water with detergent, rinse
thoroughly and dry it carefully before inserting it back in the appliance.
• When cleaning the plates you can leave them in the appliance or remove them (release locks 7 and 8
and remove the plates). If you leave the plates in the appliance, wipe them using damp cloth or tea towel.
If you remove the plates, they can be washed under running water. Then dry them thoroughly.
• Do not clean the interior or exterior surfaces using abrasive powders or cleaners or aggressive chemical
cleaning products based on lye or acids. You would damage the exterior fi nish of the appliance.
• Do not immerse the appliance in water or other liquids.
• Appliance storage: Make sure that the grill including the grilling plates is completely clean and dry, that
the drip tray is clean and dry and inserted and secured in the appliance and that the grilling plates are
secured together by sliding the adjustable latch 4 in the "LOCK" position. Wind the power cable around
the hooks qg in the rear part of the appliance. Store the appliance in a dry and clean place.

TECHNICAL DATA

Adjustable temperature range 160–220 °C
Nominal voltage: 220–240 V~ 50/60 Hz
Nominal input power: 1650–2000 W
26