Dmx-512 Connection; Operation - HQ Power VDPL710MHW14B Bedienungsanleitung

For truss mounting, use an appropriate clamp (not incl.) and fit an M10 bolt through the centre of the
(folded) bracket.
Make sure there is no flammable material within a 0.5 m radius of the device.
Have a qualified electrician carry out the electric connection.
Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
The installation has to be approved by an expert before the device is taken into service.

DMX-512 Connection

When applicable, connect an XLR cable to the female 3-pin XLR output of a controller (not incl.) and
the other side to the male 3-pin XLR input [3] of the device. Multiple devices can be linked through
serial linking. The linking cable should be a dual core, screened cable with XLR input and output
connectors.
Maximum recommended serial data link distance is 500 meters (1640 ft). Maximum recommended
number of fixtures on a serial data link is 32 fixtures.
A DMX terminator is recommended for installations where the DMX cable has to run a long distance
or is in an electrically noisy environment (e.g. discos). The terminator prevents corruption of the
digital control signal by electrical noise. The DMX terminator is simply an XLR plug with a 120 Ω
resistor between pins 2 and 3, which is then plugged into the XLR output socket [4] of the last
device in the chain.
7.

Operation

The device can be used in the following modes:
stand-alone mode: automatic or sound-activated
master/slave
with a DMX512 controller.
7.1 Control Panel Navigation
Access the control panel functions using the four panel buttons [1] located directly underneath the
display. From left to right:
Button Function
<MODE/ESC> used to access the menu or to return to a previous menu option
<UP> scrolls through the menu options in ascending order
<DOWN> scrolls through the menu options in descending order
<ENTER> used to select and store the current menu or option within the menu
The control panel display shows the menu items you select from the menu map. When a menu
function is selected, the display will show immediately the first available option for the selected menu
function. To select a menu item, press <ENTER>.
Use the <UP> and <DOWN> buttons to navigate the menu map and menu options. Press <ENTER>
to access the menu function currently displayed or to enable a menu option. To return to the
previous option or menu without changing the value, press the <MODE/ESC> button.
7.2 General Setup
Display Settings
You can choose to switch the display off automatically, and to rotate the display readout 180°.
1. Press <MODE/ESC> until <LED> is displayed and press <ENTER>.
2. Use <UP> and <DOWN> to choose the desired setting:
o <ON>: to keep the display always on.
o <OFF>: to switch the display off automatically after 15 seconds of inactivity.
3. Press <ENTER> to confirm.
4. Press <MODE/ESC> until <DISP> is displayed.
5. Press <ENTER> to toggle between normal (DISP) and rotated display (PSID).
6. Press <MODE/ESC> to quit.
V. 01 – 26/03/2013
VDPL710MHW14B/VDPL710MHW14W
5 ©Velleman nv