HQ Power VDPL710MHW14B Bedienungsanleitung Seite 6

Colour Adjustment
You can adjust the brightness of the red, green, blue, and white LEDs to set the desired output colour.
To adjust the colour:
1. Press <MODE/ESC> once to enter menu mode (<Addr> is displayed).
2. Press and hold <ENTER> for about 5 seconds until <BALA> is displayed.
3. Press <ENTER> again.
4. Use <UP> and <DOWN> to select the LED colour that you want to adjust: <Red> for the red LEDs,
<Gree> for the green LEDs, <Blue> for the blue LEDs, and <Whit> for the white LEDs. Press
<ENTER> to confirm.
5. Use <UP> and <DOWN> to set the brightness (0-255) of the selected colour and press <ENTER> to
confirm.
6. Press <MODE/ESC> to quit.
Standby Mode
If you are working with a DMX controller, the signal cable may be (accidentally) disconnected, or the
controller may be (accidentally) switched off. In this case, you can define how the device responds:
either the device stops (stand-by), or it starts running the built-in program.
1. Press <MODE/ESC> until <STBY> is displayed and press <ENTER>.
2. Use <UP> and <DOWN> to select the desired setting:
o <Yes>: the device stops if there is no DMX signal.
o <No>: the device starts running the built-in program if there is no DMX signal.
3. Press <ENTER> to confirm.
Reset Position
It may happen (for example because of a power surge) that the device deviates from the correct neutral
pan/tilt position (pan and tilt = 0°).
To reset the moving head to the correct neutral position, press <MODE/ESC> until <RSET> is displayed
and press <ENTER>. The moving head corrects its position.
Test Mode
You can run a test programme to check if all LEDs are functional.
1. Press <MODE/ESC> until <TEST> is displayed and press <ENTER>.
The device runs a test programme. During the test, "test" blinks on the display.
2. Press <ENTER> to quit.
Operation Time
The device counts the time the lights have been operational.
1. Press <MODE/ESC> until <HOUR> is displayed and press <ENTER>.
The display shows the operation time in hours.
2. Press <MODE/ESC> to quit.
7.3 Stand-Alone Mode
In stand-alone mode, the device runs a built-in program: automatic or sound-activated.
To set the device to stand-alone mode:
1. Connect nothing to the DMX input [3] of the device.
2. Press <MODE/ESC> until <SLND> is displayed and press <ENTER>.
3. Use <UP> and <DOWN> to select <MAST> and press <ENTER> to confirm.
4. Press <MODE/ESC> until <AUTO> is displayed and press <ENTER>.
5. Use <UP> and <DOWN> to select the desired setting:
o <Yes>: the device runs the built-in program.
o <No>: the device operates as a master device in sound-activated mode.
6. Press <ENTER> to confirm.
Setting the Microphone Sensitivity
For sound-activated mode, you can adjust the sensitivity of the internal microphone. To change the
sensitivity of the internal microphone, proceed as follows:
1. Press <MODE/ESC> until <SOUN> is displayed and press <ENTER>.
2. Use <UP> and <DOWN> to change the sensitivity (0-100) and press <ENTER>.
V. 01 – 26/03/2013
VDPL710MHW14B/VDPL710MHW14W
6 ©Velleman nv