Hilti TE 500 Bedienungsanleitung Seite 18

Observe the information printed in the operating instructions concerning operation, care and maintenance.
2.2 Chuck
TE‑Y (SDS‑max) chuck
2.3 Switches
Lockable control switch
Function selector switch:
Chisel adjustment (24 positions)
Chiseling
2.4 Grips
Vibration-absorbing, pivotable side handle
Vibration-absorbing grip
2.5 Protective devices
Electronic restart interlock to prevent the power tool starting unintentionally after an interruption in the electric supply
(see section 9 "Troubleshooting").
2.6 Lubrication
Gearing and hammering mechanism with separate lubrication chambers
2.7 Active vibration reduction (only TE 500‑AVR)
The power tool is equipped with an AVR active vibration reduction system which reduces vibration significantly
compared to power tools without active vibration reduction.
2.8 TPS theft protection system (optional)
The power tool may be equipped with the TPS theft protection system as an option. If the power tool is equipped with
this feature, it can be unlocked and made ready for operation only through use of the corresponding TPS key.
2.9 LED indicators
Service indicator LED (see section "Care and maintenance")
Theft protection system indicator (optional) (see section "Operation")
2.10 Items supplied as standard
1 Power tool with side handle
1 Operating instructions
1 Hilti toolbox
1 Cleaning cloth
1 Grease
2.11 Using extension cords
Use only extension cords of a type approved for the application and with conductors of adequate cross section.
The power tool may otherwise lose performance and the extension cord may overheat. Check the extension cord for
damage at regular intervals. Replace damaged extension cords.
Recommended minimum conductor cross section and max. cable lengths
Conductor cross section
Mains voltage 100V
Mains voltage 110-127 V
Mains voltage 220-240 V
Do not use extension cords with 1.25 mm² conductor cross section.
1.5 mm² 2.0 mm²
30 m
20 m 30 m
30 m
2.5 mm² 3.5 mm²
50 m
40 m
75 m
en
15