Specifications - Virutex RZ270S Gebrauchsanweisung

E N G L I S H
RZ270S TRIMMING MACHINE
Important
Read these OPERATING INSTRUCTIONS
and the attached GENERAL SAFETY
INSTRUCTIONS LEAFLET carefully before
using the machine. Make sure you have
understood them before operating the
machine for the first time.
Keep both sets of instructions for any
future queries.
1. SAFETY INSTRUCTIONS FOR
USING THE TRIMMING MACHINE
Before using the machine, carefully read
the GENERAL SAFETY INSTRUCTIONS
LEAFLET enclosed with the machine
documentation.
1. Before plugging in the machine, ensure that the
power supply voltage corresponds to what is stated on
the machine's characteristics plate.
2. Danger, keep hands clear of the working area.
3. Do not grasp the underside of the machine while it
is running.
4. Inspect the surface to be cut and remove all nails
before beginning to work.
5. Ensure that the machine slides back freely without
getting stuck. Never block the recoil mechanism.
6. When replacing the saw blade, only genuine VIRUTEX
blades should be used.
7. Do not use saw blades that are warped or damaged.
Do not use blades made of self-hardening steel.
8. Unplug the machine from the electrical outlet before
performing any maintenance operations.
9. Never use the machine where there are liquids or
excessive moisture.
10. The dust produced during cutting may prove to be
toxic or harmful to one's health. Always connect the
machine to an aspirator and use a protective mask.
11. SPARE PARTS: Only use genuine spare parts.

2. SPECIFICATIONS

Input power...................................................1,300 W
Max. cutting depth............................................47 mm
Minimum cutting height.....................................8 mm
Maximum height over base.............................35 mm
RPM (no load)..................................................5,000
8
Weight.............................................................5.6 Kg
Weighted equivalent continuous
acoustic pressure level A..................................................94 dBA
Acoustic power level A....................................................105 dBA
Uncertainty...................................................................K = 3 dbA
Wear ear protection!
Vibration total values..........................................a
Uncertainty................................................................K: 1.5 m/s
3. STANDARD EQUIPMENT
Inside the case you will find the following items:
1. RZ270S trimming machine
2. 24-tooth hard metal saw blade Ø 165
3. 3-mm. Allen key
4. 5-mm. Allen key
5. 8-mm. Allen key
6. Aspiration tube
7. 4 u. tube-cable brackets
8. Screwdriver
9. Oil flask
10. Operating instructions and miscellaneous docu-
mentation
4. OPTIONAL ACCESSORIES AND TOOLS
Hard-metal disk D.165 24z Ref. 7040314, for cutting
wooden doors and skirting boards.
Hard-metal disk D.165 30z Ref. 7040316, for cutting
metal parts, ideally suited for cutting steel sheet for
reinforced doors.
Diamond disk D.150 Ref. 7040193 for direct masonry
cutting. It may be used to cut brick, breeze blocks,
terrazzo, clinker, concrete, granite, ceramics, porcelain
and stoneware.
Side handgrip Ref. 7045728.
5. APPLICATIONS
The RZ270S trimming machine is especially designed to
enable the simple, precise trimming of door bottoms and
skirtings in order to facilitate the installation of all types
of flooring, carpeting and parquet floors without having
to dismount the aforementioned elements.
6. ADJUSTMENTS
6.1 ADJUSTING THE CUTTING HEIGHT
Unplug the machine from the electrical
outlet before making any adjustments
on it.
In order to adjust the cutting height, proceed as follows:
: <2.5 m/s
2
h
2