Using The Laser - Laserworld PL-1200G MH Bedienungsanleitung

MANUAL: Laserworld Purelight Moving Head
If this device will be operated in any way differently than described in this manual, the product may
suffer damages and the guarantee becomes void. Furthermore, any other operation may lead to
dangers like short-circuit, burns, electric shock, etc.
Keep surrounding dry and clean.
dusty environment, don't put liquid fileld containers on the device. Projector should be put in a water-
proof housing when operated outside.
Regularly open the device (see "cleaning" further down) to check for dust inside, or if fog fluid
condenses in the housing (if so rearrange hazer and/or laser position).
Operating temperature is 10~35°C. In a new installation, check after some 15-30 minutes whether
the outlet air gets too warm. Regularly check the inside for dust deposits, especially around the fans.
Let laser cool off 10minutes after 2 hours of operation,to ensure maximum lifetime for the diode.
Distance between laser aperture and projection screen should be not less than 1 meter.
Do not turn device on and immediately off again frequently.
Do not look into the laser beam directly, especially not with optical instruments.
Do not touch the device with wet hands.
When the laser diode becomes dim or broken, please contact your dealer.
When returning laser to dealer/manufacturer always use original packaging.
Maintenance should be performed every 15-day period. See "cleaning" further down.
To ensure maximum lifetime of the laser:
Don't overheat the laser:
 Always ensure good ventilation
 Don't have stage lights (especially moving heads) directed towards the laser
 Regularly clean the fans and the interior from dust
 In a new installation check the temperature after 30 minutes of operation
Keep the laser dry
 Make sure fog/hazer fluid doesn't condensate inside the laser - fog has to be in front of the
laser – not inside
 A few days after (each new) installation, open the cover to check if fluids condensate inside
 If fluids condensate inside, reposition the laser or fogger/hazer
Turn the device off, when not used. The diode is on, when the device is on. Even if it is not lit.
If the laser is equipped with a remote connector, connect an emergency switch to the Remote lock
connector on the backside, if no emergency switch is used, insert the 9 pin dongle instead. If the laser
has no remote lock, use an emergency switch in the mains connection.

Using the laser

Caution – use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
This unit should be keep dry, do not use in the rain or damp and
Page/Seite 3 of 14
Rev: June 13