Seite 1
Manual / Bedienungsanleitung / Manual de usuario Mode d´emploi Garden Series GS-60G, GS-60G move, GS-70RG move, GS-100RGB move GS-50RG Xmas, GS-60RG Xmas RC, GS-70GB Xmas RC Please spend a few minutes to read this manual fully before operating this laser! Bitte lesen Sie diese Bedienungsanleitung sorgfältig...
Seite 2
AG reserves the right to make modifications to its products. This manual and its content have been made with due care but Laserworld (Switzerland) AG can- not however, take any responsibility for any errors, omissions or any resulting damages forthwith.
Seite 3
Debido a la evolución continua del producto y mejoras técnicas, Laserworld (Suiza) AG se reserva el derecho de hacer modificaciones a sus productos. Este manual y su contenido se han hecho con el debido cuidado pero Laserworld (Suiza) AG no puede, sin embargo, asumir ninguna responsabilidad por cualquier error, omisión o cualquier daño resultante.
Content: • Legal notice, operating instructions and usage policy Product and package contents Preliminary warning notices Initial operations, safety instructions Do not open the device Warnings and other notices on the device Installation and operation Remote controller operation Service notes •...
Seite 5
1 x stake 1 x power supply unit 1 x remote control unit (only available for GS-60G move, GS-60RG RC Xmas, GS-70GB Xmas RC, GS-70RG move, GS-100RGB move) 2. Preliminary warning notices Please use this device only according to these operating instructions.
Seite 6
5. Warnings and other notices on the device Never open the device - hazardous radiation! The device contains no components which can be replaced by the user. GS-60G, GS-60G move , GS-50RG Xmas Model type Laser radiation! Avoid exposure to beam.
Seite 7
6. Installation and operation Choose a suitable indoor or outdoor location for your laser light effect. Installation: • To attach the laser to the stake, place the rubber washer in between the angle brackets of the laser and the stake and bolt them together with the thumb screw that is included in delivery.
Seite 8
Avoid sharp knocks and shocks to by improper handling, neglect this device and ensure sufficient of the safety instructions and protection during transportation. service notes will void warranty. Look after your Laserworld pro- duct. • Disconnect the device from mains when it is not needed.
Seite 9
Due to continual product developments, please check for the latest update of this product manual at www.laserworld.com. If you do have any further questions, then please contact your dealer/place of purchase or use our contact section on our web- site.
1 x Effektlaser 1 x Erdspieß 1 x Netzteil 1 x Bedienungsanleitung 1 x Fernbedienung (nur bei GS-60G move, GS-60RG RC Xmas, GS-70GB Xmas RC, GS-70RG move, GS-100RGB move) 2. Einleitende Warnhinweise Betreiben Sie das Gerät nur gemäß dieser Bedienungsanleitung.
4. Niemals das Gerät öffnen Das Gerät niemals öffnen - gefährliche Laserstrahlung! Das Gerät enthält keine Komponenten, welche durch den Anwender getauscht werden können. 5. Warnhinweise und Spezifikationen am Gerät GS-60G, GS-60G move , GS-50RG Xmas Laseraustrittsfenster Laserstrahlung! Nicht dem Produktname Strahl aussetzen.
6. Installation & Bedienung Wählen Sie für den Effektlaser einen geeigneten Platz im Innen- oder Außenbereich. Installation: • Um den Laser mit dem Erdspieß zu verbinden, die Gummi-Unterleg- scheibe zwischen die Befestigungswinkel legen und beide Winkel mittels der im Lieferumfang enthaltenen Handrändelschraube zusammenschrauben.
Beim Transport jegliche Erschüt- Nichtbeachtung Sicher- terung oder Schläge vermeiden. heits-, Pflege- und Wartungshin- Bitte das Produkt bestmöglich weise entstehen, besteht kein schützen. Laserworld bietet ent- Gewährleistungsanspruch. sprechendes Equipment an. • Trennen Sie das Gerät von der Stromversorgung wenn es nicht benutzt wird.
Sie darüber nicht in Kenntnis setzen. Bitte kontaktieren Sie für Fragen Ihren Händler. Für Servicefragen wenden Sie sich bitte an Ihren Händler oder aber an Laserworld. Verwenden Sie auschließlich Laserworld-Ersatzteile. Änderungen vorbehalten. Auf- grund der Datenmenge kann keine Gewähr für die Richtigkeit der Angaben gege- ben werden.
Seite 16
Table des matières: • Information juridique; utilisation réservée à un usage professionnel Contenu et informations Précautions avant d‘utiliser cet appareil Démarches pour la mise en service, mesures de précaution Ne pas ouvrir l’appareil Mise en garde, descriptions Utilisation et fonctionnement Télécommande RF Soin et entretien •...
1 x fiche de fixation 1 x adaptateur secteur 1 x Télécommande RC (Uniquement disponible avec GS-60G move, GS-60RG RC Xmas, GS-70GB Xmas RC, GS-70RG move, GS-100RGB move) 2. Précautions avant d’utiliser cet appareil Utilisez cet appareil seulement selon ce mode d’emploi.
4. Ne pas ouvrir l’appareil Ce produit ne contient aucune pièce interne réparable par l‘utilisateur. Ne pas ouvrir l‘appareil - radiation laser dangereuse! 5. Mise en garde, descriptions GS-60G, GS-60G move , GS-50RG Xmas Ouverture de Nom de produit sortie laser...
6. Utilisation et fonctionnement Choisissez un emplacement adéquat pour votre projecteur d‘effets laser. Installation: • Pour boulonner le laser et le piquet de terre, mettez le caoutchouc entre l’équerre de fixation du laser et du piquet de terre. Boulonnez-les avec le vis moletée.
8. Soin et entretien • Les dommages occasionnés par • Il faut éviter d’allumer l’appareil à une utilisation incorrecte, par intervalles courts et rapides, car le non-respect des consignes cela peut raccourcir considérable- d‘utilisation, de nettoyage et ment la durée de vie de la diode de service ne seront pas pris en laser! charge par la garantie Laser-...
Seite 21
Pour les questions liées au service, demandez à votre marchand ou adressez-vous à Laserworld. Utilisez uniquement des pièces de rechange Laserworld. Nous nous réservons le droit d’effectuer des modifications, améliorations à ce mode d’emploi. Laserworld décline toute responsabilité en cas d’inexactitudes ou d’erreurs dans le présent mode d’emploi.
Seite 22
Contenido: • Aviso legal Contenido del paquete Avisos preliminares Puesta en marcha, instrucciones de seguridad No abrir el dispositivo Advertencias y otros avisos en el dispositivo Instalación y funcionamiento Unidad de control remoto Notas de servicio • Declaración final • Ficha técnica y especificaciones...
1 x estaca 1 x adaptador de corriente 1 x unidad de control remoto (única versión GS-60G move, GS-60RG RC Xmas, GS-70GB Xmas RC, GS-70RG move, GS-100RGB) move 2. Avisos preliminares Por favor utilice este equipo únicamnete de acuerdo a estas instrucciones de uso.
Este producto no tiene partes reparables por el usuario en el interior. ¡No abra el dispositivo – la radiación láser puede ser peligrosa! 5. Advertencias y otros avisos en el dispositivo GS-60G, GS-60G move , GS-50RG Xmas Salida del láser Modelo ¡Radiación láser!
6. Instalación y funcionamiento Elija un lugar de interior o al aire libre adecuados para su equipo de luz láser. Instalación: • Atornille el soporte en ángulo utilizando el tornillo incluido en el paquete. Conecte el adaptador de corriente al cable de alimentación del dispositivo. Conecte el adaptador de alimentación a la red eléctrica.
Evite golpes fuertes a este dis- uso negligente o por no respetar positivo y garantice la suficiente las instrucciones de seguridad y protección durante el transporte. notas de servicio. Cuide su producto Laserworld. • Desconecte el aparato de la red cuando no vaya a utilizarlo.
Declaración final Los productos Laserworld se prueban y se inspecciona el contenido del embalaje antes de salir de nuestro almacén. Los usuarios deben seguir las normas de seguri- dad locales y las advertencias en este manual y cumplir con todos los reglamentos dentro de su lugar de uso.
Seite 28
Température d‘opération: Temperatura de funcionamiento: Dimensions: / Abmessungen: GS-60G, GS-60G move - 85 x 70 x 120 mm Dimensions: / Dimensiones: GS-50RG Xmas, GS-60RG Xmas RC, GS-70GB Xmas RC, GS-70RG (L x W x H)(B x H x T)/(H x L x P)
Seite 29
Power specifications (at laser module) / Laserleistung (am Modul) / Puissance / Datos de potencia (en el modulo láser) min. - max. 650nm 532nm 445nm GS-60G 30 - 60mW >30mW GS-60G move 30 - 60mW >30mW GS-70RG move 35 - 70mW 20mW >15mW GS-100RGB move 50-100mW 20mW >15mW...