Herunterladen Inhalt Inhalt Diese Seite drucken

User Manual; Safety Instructions; Technical Specifications - Velleman BATTEST2 Bedienungsanleitung

Vielseitiger batterietester
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 6
1.
Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for recycling. This device should be returned
to your distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, do not install or use it and contact your dealer.
2.

Safety Instructions

All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.
Do not use rechargeable batteries to power the tester.
Only test one battery at the time.
Do not modify or disassemble the device.
3.
Features
for AAA (LR3), AA (LR6), C (LR14), D (LR20), E-block (9V), CR123A, CR2, CR-V3, 2CR5,CR-P2 and
button cell batteries
battery status indicated on LCD display
tests standard, Lithium-Ion and rechargeable batteries
4.
Operation
1.
To power the battery tester, remove the battery cap at the back. Insert 1 x 1.5 V AAA alkaline
battery respecting the polarity. Do not use rechargeable batteries to power the tester. Use a fresh
alkaline battery to run the tester to ensure accurate testing results. Replace the battery cap.
2.
Insert the battery you want to test into the corresponding test channel. Make sure the battery is
firmly placed respecting the polarity. The display will show the battery condition (see below).
3.
Remove the tested battery after checking.
4.
Remove the battery powering the tester when not in use to avoid battery leakage.
Test results
Display
1 – 5 marks
6 – 10 marks
11 – 18 marks
5.

Technical Specifications

power supply ........................................................... 1 x AAA battery (LR03), not incl.
dimensions .................................................................................. 118 x 88 x 23 mm
Use this device with original accessories only. Velleman nv cannot be held responsible in the event of
damage or injury resulting from (incorrect) use of this device. For more info concerning this product
and the latest version of this manual, please visit our website www.velleman.eu. The information in
this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 02 – 29/03/2016

USER MANUAL

Battery Condition
The battery is empty. Recharge a rechargeable battery or dispose of
the battery respecting the local rules.
Battery with limited power but can still be used for a limited time.
Battery has adequate power.
BATTEST2
2
©Velleman nv

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis