Installation; Operation; Setup; Cd-Tray - Omnitronic CDP-460A Bedienungsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

Rear panel:

18. CONNECTOR PORTS

Connect the main unit here.

19. CONTROL-SOCKETS

Via the Control-socket, the respective CD-player can be remotely controlled. If you are using a mixer with

Faderstart-function connect the player with the Control Out-socket. Please note that these sockets must

never be connected with any voltage. Please refer to 6.11 Faderstart.

5. INSTALLATION

Install the CD-player on a plane surface or in your rack.

Make sure that the inclination angle will not exceed 15°, as the CD cannot be read correctly otherwise.

Please note that the LCD-display can only be read from an angle of 45° to the top and of 5° to the bottom.

Rack-installation: This CD-player is built for 19" racks (483 mm). The rack you use should be a Double-Door-

Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.

When mounting the CD-player into the rack, please make sure that there is enough space around the device

so that the heated air can be passed on. Steady overheating will damage your device.

You can fix the CD-player with four screws M6 in the rack.

Be aware that fastening the device with four screws on the front panel is not enough. In order to ensure

safety, additional fastening by using ground and side bars is necessary.

CAUTION: Make sure that the CD-player is switched off (power-switch in outer position) before you connect it

to the mains in order to avoid damages on your loudspeakers.

Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the

right/left occupation (plug-colour red/white) is the same at both devices.

Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to avoid

severe damages. Only plug the power-plug into safety-sockets.

Connect your CD-player with the mains.

Switch the CD-player on via the Power-switch.

When the device is on and the tray has no disc, "NO DISC" appears on the display.

Press Open/Close-button in order to open the disc tray. The CD-tray opens, the status-LED flashes and the

display shows "OPEN".

Inhaltsverzeichnis