Main Unit; Setup; Connection With The Mains - Omnitronic RL-8 Bedienungsanleitung

4.2 Main unit

Frontpanel:
(1) LED On/Off-switch
With this switch, you can switch the LEDs on or off.
(2) Dimmer
With the dimmer, you can adjust the lamp brightness.
(3) Aluminium-tubes with lamps
The tubes can be pulled out and be rotated in an angle of approx. 40°.
(4) Only RLD-8: Volt-display via LEDs
(5) Fuseholder
(6) Power switch
With this switch, you can switch the IEC-output sockets on the rear panel.
Rear panel:
(7) Power connection
Make sure that you are using the right voltage before you connect to mains in order to avoid severe
damages.
(8) Output sockets 1-8
Connect your devices with the IEC-output sockets.

5. SETUP

5.1 Installation
Install the device on a plane surface or install it in rack.
Rack-installation: This device is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the controller into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the controller with four screws M6 in the rack.
Connect your loads via the output-sockets. The maximum load per channel is 1380 A. Please note that the
maximum current of 10 A must never be exceeded.
Connect the device to the mains with the power cable.

5.2 Connection with the mains

Connect the device to the mains with the power-plug.
12/24 00026332.DOC, Version 2.3