Inhaltsverzeichnis
Werbung
gB Using yOUr HEadsET
0
ansWErinG anD
EnDinG calls
1.
To answer a call, briefly press the call control button or the
volume/mute button.
2.
To answer or end a call, press the call control button.
If the headset is in the headset carrying pocket when a call is
received, the carrying pocket will vibrate. Removing the
headset from the pocket will answer the call.
Returning the headset to the headset carrying pocket will end
the call.
aDJUstinG tHE VolUME
To increase the listening volume of the headset, press the upper
end (+) of the volume/mute button.
To decrease the listening volume, press the lower end (-).
WARNING:
Do not use headphones/headsets at high volumes
for an extended period of time. Doing so can cause hearing
loss. Always listen at moderate levels.
last nUMBEr rEDial
To activate last number redial, double click the call control
button. You will hear a high tone for each key press.
NOTE:
Last number redial must be supported by your device or
mobile phone provider.
UsinG tHE MUtE
To turn the mute on whilst on a call, press both sides of the
volume/mute button simultaneously until you hear a beep.
To turn the mute off, press both buttons again.
MoVinG oUt oF ranGE
As the headset is moved away from the mobile phone or
Bluetooth device, the following could occur:
•
Audio quality will degrade.
•
A beep will be heard in the headset.
•
Only the power off function will operate.
After 30 seconds, the headset will make one attempt to
reconnect to the phone or device.
UsinG VoicE actiV atED DiallinG
NOTE: To use voice activated dialling, the voice activated dialling feature must be enabled on your device. See
your Bluetooth device manual for instructions. With the headset on, one long press on the call control button
activates the voice activated dialling feature on the headset.
MUl tiPlE UsEs oF a lonG PrEss on tHE call
control BUtton
STATE OF THE
HEADSET FUNCTION
Bluetooth DEVICE
Turn on power
Power off
Re-link to
Power on
Bluetooth device
Link dropped
Power on
Reject call
Incoming call
Power on
Transfer a call between
Headset and Bluetooth device
On a call
Power on
Voice activated dialling
statUs inDicators
HEADSET STATUS
Powering on
Power on
Powering off
Power off
Charging battery
Battery fully charged
Discovery state
Missed call
Ringing
On Line Indicator (OLI)
Low battery
RESULT
Turns the power on
Re-links the device
Disconnects the call or sends the call to
Linked
voice mail depending on your device
Transfers the call from
Linked
one device to another
Linked
Activates the voice recognition feature
No call
HEADSET STATUS INDICATOR
Blue light appears and flashes every 6 seconds
Blue light flashes every 6 seconds
Red light appears and goes off
Indicator is not lit
Red light is on
Red light is off
Indicator flashes blue and red for 30 seconds
Infrequent flashing blue/red
Press any button to cancel
Rapid flashing blue/red
Blue flash every 10 seconds
Flashes red
1
Werbung
Inhaltsverzeichnis
