Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
FCC Information
FCC ID: 2ACS5-YUNST6
This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTICE:
Modifications to this product will void the user's authority to operate this equipment.
Antenna Separation Distance
When operating your transmitter, please be sure to maintain a separation distance of at least 5 cm between your body
(excluding fingers, hands, wrists, ankles and feet) and the antenna to meet RF exposure safety requirements as determined
by FCC regulations.
IC Information
IC: 11554B-YUNST6
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device."
Compliance Information for the European Union
Inductrix FPV HD (BLH9900EU)
EU Compliance Statement:
Horizon Hobby, LLC hereby declares that this product is in compliance with the essential requirements and
other relevant provisions of the RED and EMC Directives.
Instructions for disposal of WEEE by users in the European Union
This product must not be disposed of with other waste. Instead, it is the user's responsibility to dispose of their
waste equipment by handing it over to a designated collections point for the recycling of waste electrical and elec-
tronic equipment. The separate collection and recycling of your waste equipment at the time of disposal will help to
conserve natural resources and make sure that it is recycled in a manner that protects human health and the environment.
For more information about where you can drop off your waste equipment for recycling, please contact your local city office,
your household waste disposal service or where you purchased the product.
NOTICE:
For European Union customers, due to frequency restrictions, this product is intended for indoor use only.
Do not operate outdoors.
Replacement Parts
BLH9901 Prop Set (8)
BLH9902 Motor Set (2)
BLH9903 FC board
BLH9904 Camera board
BLH9905 Lens
BLH9906 Canopy
BLH9907 Plannar antenna
BLH9908 Main Frame
BLH9909 Screw set
EFLB5501S25UM 550mAh 1S 3.7V 25C LiPo
8
Werbung
Inhaltsverzeichnis
