Beninca SC.RF Bedienungsanleitung Seite 9

In order to memorise the code on channel 1, proceed as fol-
lows:
1) Press push-button P of the SC-RF RECEIVER once
2) The LED LD1 switches on with RED light
3) Within 30 seconds, press push-button S1 of the RF/RF.SUN
device for around 4 seconds.
4) The LED LD1 switches off temporarily and a buzz indicates
that the storage in memory has been successful.
5) Await that the LED LD1 switches off
In order to memorise the code on channel 2, proceed as fol-
lows:
1) Press push-button P of the SC-RF RECEIVER once
2) The LED LD1 switches on with RED light.
3) Press push-button P once again
4) The LED LD1 switches to GREEN light.
5) Within 30 seconds, press push-button S1 of the RF/RF.SUN
device for around 4 seconds.
6) The LED LD1 switches off temporarily and a buzz indicates
that the storage in memory has been successful.
7) Await that the LED LD1 switches off.
IMPORTANT!
Up to 4 different devices can be memorised on each sin-
gle channel. When the memory available is full, the LED will
flash three times.
AUTOTEST (Self-testing)
To enhance the safety of the system, the AUTOTEST function
of SC.RF can be used.
If the sensitive safety edge is activated and then restored when
the obstacle has been removed, the AUTOTEST function will
carry out a series of relay tests before resetting the system.
Also the control unit must have a PHOTOTEST function.
In order to activate the AUTOTEST function:
Open the jumper/s of channel/s (W1 or W2) for which a self-
testing is desired.
Connect input TEST of SC.RF to the PHOTOTEST input of the
control unit, as shown in Figure 3.
Press push-button P for 3 times consecutively, the LED LD1
switches on with ORANGE light.
If the LED flashes slowly (1 flash/sec), this means that the AU-
TOTEST function is OFF. Press the push-button P for around 2
seconds and the LED now flashes more rapidly (2 flashes/sec).
The AUTOTEST function is now activated.
The function is enabled ONLY if all the above-mentioned ope-
rations are performed.
HOW TO RESET THE SC.RF RECEIVER
If all presetting must be erased and the SC.RF receiver must be
restored to factory pre-setting:
- Cut power supply off.
- Press push-button P and keep it pressed.
- Power the system again, keeping the push-button P pressed
on the receiver.
- The LED starts flashing with red/green light. After around 5
seconds, when the light turns orange, release the button P and
wait that the LED switches off.
DIAGNOSTICS
During normal operation, the colour of the LED indicates the
status of the two channels:
Red LED – channel 1 activated
Green LED – channel 2 activated
The Buzzer (if enabled) indicates the following events:
9