Brewing Coffee - Grundig KM 6330 Bedienungsanleitung

OPERATION _________________________________
Preparation
:
1
Remove all packaging and stickers and dis-
pose them according to applicable legal regu-
lations.
2 Before using the appliance for first time, clean
all parts which come into contact with water
carefully. Please see full details in the "Clean-
ing and Care" section.
3
Make sure that the appliance is placed in an
upright position and on a stable, flat, clean,
dry, and non-slip surface.

Brewing Coffee

1
Open the water tank cover
water tank with drinking water. The water
B
should not exceed the max. level marked on
the water gauge
D
of water, but do not fill past the "MAX" mark.
Note
Use only clean, cold, and fresh drinking
7
water.
2
Add coffee powder into filter. Usually a cup of
coffee need a level spoon of coffee powder
but you may adjust according to personal
taste. Then close the water tank cover
3 Place the glass jug
.
G
4 Connect the plug to the wall socket. The LCD
will display 12:00 o clock with flashing blue
light.
5
Press the On/Off
L
process begins.
6
Remove out glass jug
brewing (about one minute later after the cof-
fee stops dripping out).
7
Even after the process has finished can you
keep the appliance energized. The coffee will
be kept warm . The appliance will be cut off
G
power automatically after two hours if it has
not been manually disconnected at the com-
pletion of brewing.
18 ENGLISH
and fill the
A
. with the required amount
.
A
on the warming plate
F
button. And the brewing
to serve when finish
F
Notes
For an optimum coffee taste, serve it after
7
brewing.
Caution:
If the swivel filter holder is not closed or the
7
glass jug is not placed accurately, the
F
drip - stop function will not function properly.
It could cause hot water or hot coffee to over-
flow.
Notes
The brewing process can be stopped at any
7
time by pressing the On/Off
Caution
Make sure to place the glass jug
7
warming plate quickly (max. 30 seconds).
G
Otherwise the brewed coffee from the filter
could overflow. If you want to use the glass
jug for more than 30 seconds, switch off
F
the appliance.
Never open the swivel filter holder during the
7
brewing process, even if no water is draining
from the filter. Extremely hot water or coffee
can spill out from the swivel filter holder and
cause injury. If water or coffee is not drain-
ing from the swivel filter holder, immediately
unplug the appliance and wait 10 minutes
before opening and checking the swivel filter
holder.
When the brewing process ends and the
7
water level indicator with MAX marking is
empty, there will still be hot liquid in the swivel
filter holder. Wait a few minutes for the rest of
the liquid to drip into the glass jug
8 Remove the glass jug
plate , as soon as the brewing process has
G
finished and the glass jug
coffee is ready for use.
9
To turn the appliance off, press the
again.
– Switching the
L
10
Disconnect the appliance from the wall
socket.
button.
L
on the
F
.
F
from the warming
F
is filled. The
F
button
L
turns off the appliance.