CBE PC -540HY Bedienungsanleitung Seite 43

STERN PANEL
1
2
3
1)
Doglight switch, it depends on the main switch
2)
Pushbutton for the setting of the alarm-clock; it is used to shift between hours and minutes setting.
3)
Pushbutton for the activation and deactivation of the alarm clock and for the setting of the alarm-clock
time.
FUNCTIONS
The current time, external temperature and burglar device and gas detectors alarms are displayed:
- GAS ALARM "
- LEFT locker forced ALM LKR L/H (OPTIONAL)
- RIGHT and/or rear locker forced ALM LKR R/H-BK (OPTIONAL)
- Van's door forced ALM DOOR OPEN (OPTIONAL)
- Volumetric sensors alarm when the burglar device is activated "ALM VOLUMETRIC"
(OPTIONAL)
. When one of the alarms turns on, the relevant message is displayed until the reason of alarm is
eliminated.
It's on only when the contol panel is on in stand-by mode.
The watch is controlled to the control panel.
SET-UP AND FUNCTIONING OF THE ALARM-CLOCK
To start the setting of the alarm-clock push the button ref. 2 for about 2 secs; hours' digits are blinking
on the display.
The button ref. 3 allows to set the digits.
Pushing again the button ref. 2, you can shift to the minutes setting; minutes' digits are blinking on
the display.
A third pressure on the button ref. 2 saves the set-up.
After the set-up it is necessary to activate the alarm pushing the button ref. 3 for about 2 secs.
The alarm remains active until deactivated by pushing the button ref. 3.
The symbol on the display shows that the alarm is active.
%
As the selected time is reached and the alarm is active, the alarm clock starts beeping for 1 minute or
until a button (ref. 2 or 3) is pushed.
"
" "
"
"
"
"
43