MSI X58M serie Handbuch Seite 49

▶ Auto OverClock Technology
Settng ths tem to [Max FSB] allows the system to detect the FSB lmtaton for over-
clockng automatcally. If overclockng fals, you can try the lower FSB clock for over-
clockng successfully.
▶ Adjusted Core Frequency (MHz)
It shows the adjusted CPU frequency (Base clock x Rato). Read-only.
▶ QPI Configuraton
Press <Enter> to enter the sub-menu and the followng screen appears.
▶ QPI Lnks Speed
Ths tem allows you to select the QPI lnks speed type.
▶ QPI Frequency
Ths tem allows you to select the QPI frequency.
▶ Memory-Z
Press <Enter> to enter the sub-menu and the followng screen appears.
▶ DIMM1~6 Memory SPD Informaton
Press <Enter> to enter the sub-menu. The sub-menu dsplays the nformatons of
nstalled memory.
▶ Advance DRAM Configuraton
Press <Enter> to enter the sub-menu and the followng screen appears.
▶ 1N/2N Memory Tmng
Ths tem controls the SDRAM command rate. Select [1N] makes SDRAM sgnal
controller to run at 1N (N=clock cycles) rate. Selectng [2N] makes SDRAM sgnal
controller run at 2N rate.
▶ CAS Latency (CL)
Ths controls the CAS latency, whch determnes the tmng delay (n clock cycles)
before SDRAM starts a read command after recevng t.
▶ tRCD
When DRAM s refreshed, both rows and columns are addressed separately. Ths
setup tem allows you to determne the tmng of the transton from RAS (row ad-
dress strobe) to CAS (column address strobe). The less the clock cycles, the faster
the DRAM performance.
▶ tRP
Ths settng controls the number of cycles for Row Address Strobe (RAS) to be
allowed to precharge. If nsufficent tme s allowed for the RAS to accumulate ts
charge before DRAM refresh, refresh may be ncomplete and DRAM may fal to
retan data. Ths tem apples only when synchronous DRAM s nstalled n the sys-
tem.
En-39