SUNTEC Heat Ray 3000 Carbon Bedienungsanleitung Seite 15

timing one hour, 02 indicates timing two hours, etc.
Remote control
Definition of the buttons on the remote control
The functions of the appliance may be controlled via the buttons on your remote control and LCD screen. You may also
control some of the functions of your heater through the
1000W: First heating level. After turning on the appliance, you can choose low heating level.
2000W: Second heating level. After turning on the appliance, you can choose moderate heating level.
3000W: Third heating level. After turn on the appliance, you can choose high heating level.
Timer. After the function is on, 1-24 hours timing shutdown can be adjusted. The digital screen showing 01 means one hour,
02 means two hours, etc
W arning! Please insert the batteries in your remote control.
Insert batteries
Turn the remote control onto the back and pull out battery cover. Insert the batteries in accordance with the
instructions and polarity (+/-) of the batteries
- Insert 2AAA / Alkaline type batteries into your remote control.
- Change the batteries in the same way depicted above
Warning:
Please use the battery type indicated in this manual. Improper or incorrect use of batteries may cause corrosion or battery
leakage, which could cause personal injury or damage to property
Maintenance and care
Maintenance
Attention! Careful and regular maintenance of infrared heater is required to attain a long and efficient operation of your
appliance.
1. Check the cleanliness of the reflector and IR-filament at least once a month. If necessary, apply cleaning and
maintenance instructions.
2. The number of checks may be increased considering the amount of the dust in the environment.
3. Check the deformation of the reflector, wire and frame visually while cleaning the appliance. In case of any deformation,
consult a qualified technician.
4. Check the power cable and plug visually while cleaning the appliance. In case of any deformation, consult a qualified
technician.
5. It is recommended to change the reflector every 2 years for more efficient operation.
Cleaning
Attention! Regular and careful cleaning helps your heater operate for longer years and more efficiently.
1. Unplug your power cable for your safety before cleaning your appliance.
2. Take out the front grid wire through the inlets on the frame using a slotted screwdriver.
3. Make sure that the power is off for your safety. Power cable plug must be unplugged.
4. The reflector and filament must be cleaned with a soft cloth, a smooth brush or cool or dry air. The cloth may be damp but
never too wet and the cleaner should not include any chemical.
5. Refrain from using cleaning material likely to damage the reflector (cleanser etc.).
6. Insert the wire grid using a slotted screwdriver.
Note Concerning protection of the environment
This product must not be disposed of via normal household waste after its service life, but must be taken to a
collection station for the recycling of electrical and electronic devices. The symbol on the product, the operating
instructions or the packaging indicate such disposal procedures. The materials are recycable in accordance with
buttons on the front side of the heater.
.
.
.
15