Power Supplier Function - Tecnotest 5880 Bedienungsanleitung

________________________________________________________________________ SMART CHARGER
7.0 -

POWER SUPPLIER FUNCTION

The battery charger can works as stabilized power supplier. According to the selected
voltage and the applied load the tool supplies the relevant current with maximum
30 Ampere.
•
Select POWER SUPPLIER from the TYPE OF CHARGE menu and press ENTER to
start the battery charger as power supplier.
By the UP or DOWN arrow keys the displayed voltage can be modified (increased or
decreased) with a 0,1 V variation at each pressure. Then, after selecting the desired
voltage the current supply can be started.
According to the type of selected voltage from the SELECT BATTERY menu select one
of the following values:
With 6 V voltage available ranges from 0,1 V to 7 V.
With 12 V voltage available ranges from 0,1 V to 14 V.
With 24 V voltage available ranges from 0,1 V to 30 V.
ATTENTION:
Be very careful during the use of the power supplier function.
Before starting the power supplier function be sure the voltage
selected is suitable to the connected load. This function has no control
on voltage and on correct polarity of the battery/connected load.
•
Press START to supply the load.
NOTA BENE:
The current distribution to the load can be stopped at any moment by pressing STOP.
The following menu is displayed:
where
V = voltage measured at the battery charger output in Volts.
I = current distributed by the battery charger in Ampere (maximum 30 A).
OPERATING INSTRUCTIONS
POWER SUPPLIER
+
V: 12,6
[START]
−
POWER SUPPLY
V: 12,6 I: 2,2

43