Zanussi ZEI3921 Benutzerinformation Seite 21

• If the fixing bracket is near to the terminal
block, do not let the connection cable come
in contact with the edge of the bracket.
Electrical connection
• Make sure that the rated voltage and type of
power on the rating plate agree with the
voltage and the power of the local power
supply.
• Always use a correctly installed shockproof
socket.
• Make sure that there is an access to the
mains plug after installation.
• Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.
• There is a risk of fire when the appliance is
in connection with an extension cable, an
adapter or a multiple connection. Make sure
that the ground connection agrees with the
standards and regulations.
• Do not let the power cable to heat up to a
temperature higher than 90° C.
Make sure that you connect the blue neutral
cable to the terminal with a letter "N" on it.
Connect the brown (or black) phase cable to
the terminal which has a letter "L". Keep the
phase cable connected at all times.
Replacement of the connection cable
To replace the connection cable use only
H05V2V2-F T90 or equivalent type. Make sure
that the cable section is applicable to the volt-
age and the working temperature. The yellow/
green earth wire must be approximately 2 cm
longer than the brown (or black) phase wire.
Building in
min. 650 mm
If several 30 cm hobs are to be installed side
by side into the same cut out, an assembly kit
including a support side bracket and supple-
www.zanussi.com
mentary seals is available at our Service Cen-
tres. The relevant installation instructions are
supplied within the kit package.
min.
55mm
Possibilities for insertion
Kitchen unit with door
490 mm
The panel installed below the hob must be
easy to remove and let an easy access in case
270 mm
a technical assistance intervention is necessa-
ry.
R 5mm
+1
490 mm
+1
270 mm
21