Warning Note; Important Notes - TermaTech TT10 Montage- Und Bedienungsanleitung

given in Building Regulations Approved Document J and also in these stove instructions.
If the stove is to be installed on a combustible floor surface, it must be covered with a non-combu-
stible material at least 12mm thick, in accordance with Building Regulations Approved Document
J, to a distance of 30 cm in front of the stove and 15 cm to each side measuring from the door of
the combustion chamber.
Combustion air supply
In order for the stove to perform efficiently and safely there must be an adequate air supply into
the room in which the stove is installed to provide combustion air. The provision of air supply to the
stove must be in accordance with current Building Regulations Approved Document J. An opening
window is not appropriate for this purpose.
Connection to chimney
Stoves may have a choice of either a rear or top flue gas connector that allows connection to either
a masonry chimney or a prefabricated factory made insulated metal chimney in accordance with
their instructions. In some cases it may be necessary to fit an adaptor to increase the diameter of
the flue to the minimum required 150 mm section of the chimney or liner.
Commissioning and handover
Ensure all parts are fitted in accordance with the instructions.
On completion of the installation allow a suitable period of time for any fire cement and mortar to
dry out, before lighting the stove. Once the stove is under fire check all seals for soundness and
check that the flue is functioning correctly and that all products of combustion are vented safely to
atmosphere via the chimney terminal.
On completion of the installation and commissioning ensure that the operating instructions for the
stove are left with the customer. Ensure to advise the customer on the correct use of the appliance
and warn them to use only the recommended fuel for the stove.
Advise the user what to do should smoke or fumes be emitted from the stove. The customer should
be warned to use a fireguard to BS 8423:2002 (Replaces BS 6539) in the presence of children, aged
and/or infirm persons.
READ THE INSTRUCTION BOOK AND THESE INSTRUCTIONS CAREFULLY BEFORE USING
THE STOVE

WARNING NOTE

Properly installed, operated and maintained this stove will not emit fumes into the dwelling. Oc-
casional fumes from de ashing and re fuelling may occur. However, persistent fume emission is
potentially dangerous and must not be tolerated. If fume emission does persist, then the following
immediate action should be taken:
(a) Open doors and windows to ventilate the room and then leave the premises.
(b) Let the fire go out.
(c) Check for flue or chimney blockage and clean if required
(d) Do not attempt to relight the fire until the cause of the fume emission has been
identified and corrected. If necessary seek expert advice.
The most common cause of fume emission is flueway or chimney blockage.
For your own safety these must be kept clean at all times.

IMPORTANT NOTES

General
Before lighting the stove check with the installer that the installation work and commissioning
checks described above have been carried out correctly and that the chimney has been swept clean,
is sound and free from any obstructions. As part of the stoves' commissioning and handover the
installer should have shown you how to operate the stove correctly.
CO Alarm
Your installer should have fitted a CO alarm in the same room as the appliance. If the alarm sounds
unexpectedly, follow the instructions given under "Warning Note" above.
Use of fireguard
When using the stove in situations where children, aged and/or infirm persons are present a fire-
guard must be used to prevent accidental contact with the stove. The fireguard should be manu-
factured in accordance with BS 8423:2002 (Replaces BS 6539).
25