Safety Instruction For Polisher - MaxPro MPPO1200/180VC Bedienungsanleitung

other condition that may affect the power tool's operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less
likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into
account the working conditions and the work to be performed. Use of the power tool for operations
different from those intended could result in a hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.

SAFETY INSTRUCTION FOR POLISHER

Symbols
Observe the dimensions of the saw blade. The hole diameter must match the tool
spindle without play.
Danger Area! Keep hands far away from the cutting area while the machine is running.
Keep bystanders away.
1) Safety instructions for all operations
a) This power tool is intended to function as a polisher. Read all safety warnings, instructions, illustrations
and specifications provided with this power tool. Failure to follow all instructions listed below may result in
electric shock, fire and/or serious injury.
b) This power tool is not recommended for grinding, sanding, wire brushing or cutting off operations.
Operations for which the power tool was not designed may create a hazard and cause personal injury.
c) Do not allow any loose portion of the polishing bonnet or its attachment strings to spin freely. Tuck away
or trim any loose attachment strings. Loose and spinning attachment strings can entangle your fingers or
snag on the workpiece.
d) Do not use accessories which are not specifically designed and recommended by the tool manufacturer.
Just because the accessory can be attached to your power tool, it does not assure safe operation.
e) The rated speed of the accessory must be at least equal to the maximum speed marked on the power
tool. Accessories running faster than their rated speed can fly apart.
f) The outside diameter and the thickness of your accessory must be within the capacity rating of your
power tool. Incorrectly sized accessories cannot be adequately guarded or controlled.
g) The arbour size of wheels, flanges, backing pads or any other accessory must properly fit the spindle of
the power tool. Accessories with arbour holes that do not match the mounting hardware of the power tool
will run out of balance, vibrate excessively and may cause loss of control.
h) Do not use a damaged accessory. Before each use inspect the accessory such as abrasive wheels for
chips and cracks, backing pads for cracks, tear or excess wear, wire brushes for loose or cracked wires. If the
power tool or accessory is dropped, inspect for damage or install an undamaged accessory. After inspecting
and installing an accessory, position yourself and bystanders away from the plane of the rotating accessory
and run the power tool at maximum no load speed for one minute. Damaged accessories will normally
break apart during this test time.
i) Wear personal protective equipment. Depending on application, use face shield, safety goggles or
safety glasses. As appropriate, wear dust mask, hearing protectors, gloves and shop apron capable of
stopping small abrasive or work piece fragments. The eye protection must be capable of stopping flying
4 EN