Operating The Tool; Cleaning And Maintenence; Environment - MaxPro MPPO1200/180VC Bedienungsanleitung

accessory runs freely by turning it by hand - test-run tool for at least 30 seconds at highest no-load speed
in a safe position - stop immediately in case of considerable vibration or other defects and check tool to
determine the cause
4.On/off
- switch on/off the tool by pulling/releasing trigger H
5.Electronic soft
-start Ensures reaching the maximum speed smoothly without a sudden impact when tool is switched on
6.Switch locking for continuous use
- pull trigger
- press knob J with your thumb
- unlock the switch by pulling again trigger H and then releasing it
7.Speed control
- with wheel K the maximum speed can be adjusted from low to high (1-MAX)
- start with wheel K in position 1 (lower speed)
- if needed, select a higher speed while the tool runs
- the optimal working speed depends on the material and can be determined with practical trials

8.Operating the tool

- switch on the tool - place the tool fully on the surface to be polished and move it evenly by sections - one
move should overlap the previous move by one half
- do not stop at a single spot to avoid burning the coating
- do not move the tool in circles to avoid staining or burning the coating ! before switching off the tool, you
should lift it from the workpiece ! the accessory continues to rotate for a short time after the tool has been
switched off
9.Holding and guiding the tool
while working, always hold the tool at the area(s)
- always hold the tool firmly with both hands, so you will have full control of the tool at all times
- provide for a secure stance ! do not apply so much pressure on the tool that it comes to a standstill
- keep ventilation slots L uncovered

CLEANING AND MAINTENENCE

Protect the tool from impact, shock and grease Always keep tool and cord clean (especially ventilation slots)
disconnect the plug before cleaning
do not attempt to clean ventilation slots by inserting pointed objects through openings

ENVIRONMENT

• Do not dispose of electric tools, accessories and packaging together with household waste material -
in observance of European Directive 2002/96/EC on waste of electric and electronic equipment and its
implementation in accordance with national law, electric tools that have reached the end of their life must
be collected separately and returned to an environmentally compatible recycling facility.
EN 7