auna multimedia TT-18SB Bedienungsanleitung Seite 13

5. PRESS PRESET UP (17) OR PRESET DOWN (16) TO CHOOSE THE PRESE RADIO STATIONS.
6. THE NUMBER OF STATIONS CAN BE FOUND AND STORED IS DEPENDED ON THE RECEPTION OF
DIFFERENT AREA AND COUNTRIES.
AUTO PRESET RADIO STATIONS
1. DURING RADIO MODE, PRESS THE PLAY/PAUSE (12), THE UNIT WILL AUTOMATICLLY SCAN THE
RADIO FREQUENCY. WHEN THE CLEAR SIGNAL IS FOUND, IT WILL AUTOMATICALLY STORE THE
RADIO STATION, STARTING FROM PROGRAM NUMBER 1.
2. THE NUMBER OF STATIONS CAN BE FOUND AND STORED IS DEPENDED ON THE RECEPTION OF
DIFFERENT AREA AND COUNTRIES.
FM & FM-STEREO RECEPTION
• PRESS "FM ST." BUTTON ON THE REMOTE CONTROL TO SELTECT FM MONO OR FM STEREO MODE.
WHEN STEREO SIGNAL ARE WEAK. IT IS PREFERABLE TO RECEIVE THE PROGRAM IN MONO.
• "ST" ICON LIGHT UP ON THE DISPLAY TO SHOW FM STEREO MODE IS RECEIVING.
HINTS FOR BETTER RECEPTIO
1. AM: THERE IS A BUILT-IN AM BAR ANTENNA. IF AM RECECPTION IS WEAK, SLIGHTLY ROTATING
OR RE-POSITIONING OF THE UNIT WILL USUALLY IMPROVE THE AM RECEPTION.
2. FM : THE RECEIVER HAS A BUILT-IN FM WIRE ANTENNA HANGING AT THE REAR CABINET. THIS
WIRE SHOULD BE TOTALLY UNRAVELED AND EXTENDED FOR BEST RECEPTION.
FM & FM-STEREO RADIO ENCODING
1. PRESS FUNCTION BUTTON (4) TO SELECT "TUNE" MODE AND SELECT THE DESIRED BAND BY
RADIO BAND BUTTON (13) (AM OR FM).
2. INSERT MEMORY DEVICE (USB DRIVE, SD OR MMC CARD)
3. PRESS THE "REC" BUTTON (2), IT WILL TAKE 3-5 SECONDS TO READ MEMORY DEVICE. THEN
USB OR SD ICON WILL BE FLASHING.
4. PRESS SKIP UP
MODE (USB OR SD) FOR ENCODING. THEN PRESS THE "REC" BUTTON (2) AGAIN TO CONFIRM.
AND THE SYSTEM IS STARTING THE ENCODING MODE AFTER FEW SECONDSS.
5. IF ONLY USB DRIVE, SD OR MMC CARD IS INSERTED, STEP 4 CAN BE SKIPPED.
6. THE REC ICON WILL BE FLASHING ON THE DISPLAY DURNIG ENCODING.
7. TO FINISH ENCODING, PRESS STOP
8. TO HEAR NEWLY ENCODED TRACK:
- PRESS FUNCTION BUTTON TO SELECT USB OR SD MODE.
- PRESS SKIP UP BUTTON OR SKIP DOWN BUTTON TO SELECT THE NEWLY ENCODED TRACK.
- THE NEWLY ENCODED TRACK IS ALWAYS STORED AS THE LAST TRACK IN USB/SD.
- DURING PLAYBACK FROM USB OR SD, PRESS REC BUTTON TO SWITCH BETWEEN TRACKS
ENCODED - BY THIS UNIT OR OTHER TRACKS STORED IN THE USB (OR SD) ORIGINALLY.
REMARK:
- THE RECORDING SPEED IS 1:1 AND ACCORDING TO THE ACTUAL PLAYING TIME OF FM OR FM-ST
RADIO
- THE RECORDING FORMAT IS PRESET AT – MP3 BIT RATE : 128 KBPS
- DURING FM & FM-STEREO RADIO ENCODING, RADIO FREQEUNCY IS FXIED AND CANNOT BE
TUNED
BUTTON (15) OR SKIP DOWN
BUTTON (13)
BUTTON (14) TO SELECT DESIRED
13