auna multimedia TT-18SB Bedienungsanleitung Seite 12

PRECAUTIONS FOR USE
INSTALLATION
· UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
· DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAINS VOLTAGE AND
BEFORE ALL OTHER CONNECTIONS HAVE BEEN MADE.
· DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF SEVERAL
CENTIMETERS AROUND THE UNIT FOR VENTILATION.
CONNECTION
1. CONNECT AC POWER CORD (28) TO AC OUTLET
2. PUSH THE POWER KNOB (18) TO SWITCH ON THE UNIT, STANDBY INDICATOR (5) WILL BE OFF.
IF THE BACKLIGHT ON THE LCD DISPLAY LIGHTS UP, IT MEANS THE POWER SUPPLY IS NORMAL,
NOW YOUR SYSTEM IS READY FOR USE.
SETTING THE CLOCK
1 WHEN THE STANDBY INDICATOR (5) LIGHT UP, UNIT IS IN THE STANDBY MODE.
2 DURING STANDBY MODE, SELECT BETWEEN 12H OR 24H MODE: PRESS AND HOLD MODE
BUTTON (1) FOR 3-5 SECONDSS, 12H / 24H WILL BE FLASHING. PRESS SKIP UP (15) OR SKIP
DOWN (14) BUTTON TO SELECT 12H / 24H MODE. PRESS MODE BUTTON (1) AGAIN TO CONFIRM.
3 SETTING HOUR: PRESS SKIP UP (15) OR SKIP DOWN (14) BUTTON TO SELECT THE CORRECT
HOUR, THEN PRESS MODE BUTTON (1) AGAIN TO CONFIRM.
4 SETTING MINUTE: AFTER STEP 3 IS COMPLETED, PRESS SKIP UP (15) OR SKIP DOWN (14)
BUTTON TO SELECT THE CORRECT MINUTE, THEN PRESS MODE BUTTON (1) AGAIN TO CONFIRM.
TIMER FUNCTION
1. PUSH THE POWER K
NOB (18) TILL
FROM STANDBY MODE TO OPERATION MODE.
2. WHEN THE UNIT IS IN OPERATION MODE, PRESS SLEEP BUTTON (3) REPEATEDLY TO CHOOSE
THE SLEEP TIME MINUTES FROM 90>80>70.....>10 OFF.
3. SLEEP TIME SETTING IS STORED WHEN THE "SLEEP" ICON LIGHTS UP ON THE DISPLAY.
4. WHEN THE SLEEP TIME MINUTES IS OVER, UNIT WILL BE SWITCHED TO STANDBY MODE
AUTOMATICALLY.
LISTENING TO RADIO
RADIO TUNING
1. PRESS FUNCTION BUTTON (4) TO SELECT "TUNE" MODE.
2. SELECT THE DESIRED BAND BY RADIO BAND BUTTON (13) (AM OR FM).
3. TUNE TO THE REQUIRED STATION BY PRESSING SKIP UP
FOR 1-2 SECONDS, AND THEN RELEASE.
4. THE UNIT WILL START SEEKING AUTOMATICALLY AND STOP WHEN A RADIO STATION IS FOUND.
MANUAL PRESET RADIO STATIONS
1. WHEN THE DESIRED RADIO STATION IS FOUND, PRESS MODE BUTTON (1), PROGRAM NUMBER
WILL BE FLASHING.
2. PRESS PRESET UP (17) OR PRESET DOWN (16) TO CHOOSE THE PROGRAM NUMBER FOR
STORING THE DESIRED RADIO STATION.
3. PRESS MODE BUTTON (1) AGAIN TO CONFIRM, PROGRAM NUMBER WILL STOP TO FLASH.
4. REPEAT STEP 2 & 3 UNTIL ALL DESIRED RADIO STATIONS IS BEING FOUND AND STORED
THE STANDBY INDICATOR (5) LIGHT OFF. UNIT
(15) OR SKIP DOWN
IS TURNING
(14) BUTTON
12