Setting The Programming Code - Siemens Codoor CD3500 Installations- Und Benutzerhandbuch

6
Codoor also incorporates a buzzer, both to confirm each key press (if
required) and to indicate "battery low" by sounding a low tone (see
section Backup Power Supply). Otherwise, the buzzer sounds to confirm
successful programming.
The programming code must be set before the unit is fitted to the door

Setting the programming code

When Codoor is delivered, the memory is completely empty. The first
thing you have to do is to set a programming code, before you fit Codoor
to a door. To set the programming code for the first time, connect the
batteries and proceed as follows:
1. Press the reset button on the rear of Codoor and hold it
down as you press the # button for at least 2 seconds.
2. The red LED will flash quickly, accompanied by simultaneous
sounding of the buzzer
3. While buzzer sound - press , then
enter the desired 6-digit programming
code. Finish by pressing .
4. The green LED is lit for 2 seconds. A rising tone from the buzzer
confirms that the programming code has been set.
NoTE! Programming must be done while the red LED flashes and the
buzzer sounds. Do not forget to write to down the chosen digits.
Programming Code
Code 1:
Code 2:
Code 3:
CD3500 & CD4000 Installation and User manual
Code 4:
Code 5:
Code 6:
R R
 
Note! The first 4 digits
in the programming
code must never be
used for any of the 9
access codes.
Code 7:
Code 8:
Code 9:
+ +
# #
 