Petsafe 100 Serie Schnellstartanleitung Seite 4

The PetSafe Microchip Cat Flap is suitable to fit most doors or partitions although
®
additional materials and competent DIY skills may be required. This cat flap is
designed to adapt easily to cut-out sizes for Staywell
and Petporte smartflap series cat flaps. Some simple DIY skills are required and
™
minor adjustments to the cut-out or additional accessories might be needed.
Installation – Measurement and Marking
Measure the belly height
of your cat. This is usually
100 mm (3 ¹ ₅ ⁄₁₆") –150 mm
(5 ¹ ₅ ⁄₁₆") (Fig. A).
Mark this measurement on the
outside of your door and draw
a straight horizontal line 168 mm (6 ₅ ⁄₈") long, preferably in the center of the
door (Fig. B).
Please keep in mind that this horizontal line will eventually be the bottom of the
hole you will cut in your door. The frame of the cat flap will be 25 mm lower. If
an installation adaptor is used, then the frame will be lower.
Note: This line may have to be raised slightly to allow for at least 50 mm (2")
from the bottom of the door.
Important: Do not cut the tunnel. Key components are contained
within the tunnel and any alteration to the tunnel will affect functionality.
Installation – Wooden, PVC, or uPVC
Doors without Metal
Before beginning, please check if your door has a metal core. If a metal core
or metal plate is found, follow the
Installation – Metal or Metal Core
Doors instructions.
1. Attach the supplied Cutting Template
to the outside of your door in the
correct position ensuring that it is the
right way up and level (Fig. C).
4
200, 300, 400, 500, 900
®
Fig. A Fig. B
(x)
(x)
Fig. C Fig. D
(X)
(X)
petsafe.com
2. Drill four corner holes with a 12 mm (½") diameter drill bit as marked on
the Cutting Template through the door. Ensure that the drill remains straight
and level.
3. Using a jig or key-hole saw, cut along the appropriate line as indicated
on the Cutting Template. (Fig. D).
4. Temporarily place the interior frame into the cutout. Level
the cat flap until it is in the proper position in the center
of the cutout. On the outside install the exterior frame.
Use a pencil to mark screw holes through the mounting
holes on the exterior frame (Fig. E).
5. Remove the interior and exterior frame and drill the
screw holes with a 6mm (¼") drill bit (Fig. F). Ensure
that the drill remains straight and level.
6. Clean the area from any dust, dirt or debris.
7. From the interior of the home, insert the cat flap interior
frame into the opening.
8. From the exterior of the home, place the exterior frame
onto the interior frame.
9. Making sure to center the cat flap in the hole. Three (3) different lengths
of screws have been provided with this cat flap. Select the appropriate
length. Using a manual screw driver, screw the exterior frame to the
interior frame.
10. Insert the two blanking plugs over the screws on the exterior frame.
11. Remove the batteries from the cat flap and wait for 30 seconds. Re-install
the batteries and battery cover. The cat flap is ready to use.
Fig. E
Fig. F