Petsafe 100 Serie Schnellstartanleitung Seite 3

Thank you for choosing the PetSafe Brand. You and your pet deserve a
®
companionship that includes memorable moments and a shared understanding
together. Our products and training tools enhance the relationship between
pets and their owners. If you have any questions about our products
or training your pet, please visit our website at www.petsafe.com
or contact our Customer Care Centre. For a listing of Customer Care
Centre telephone numbers, visit our website at www.petsafe.com.
Programming Cats into the PetSafe
Microchip Cat Flap
Your PetSafe Microchip Cat Flap is designed to work with most 15-digit
®
microchips (FDX-B) used for pets. Before you begin setup or installation of the
cat flap, please ensure your cat has the correct type of microchip.
To begin operation, the cat flap must learn the unique microchip Identification
Number (ID) of your cat. Please follow the steps below to begin the setup of
your cat flap:
1. The cat flap will be factory pre-set in the locked position. Ensure the
manual lock is set to the In and Out position (See Fig. H on page 7).
2. Remove the battery cover, set aside the provided hardware pack, and
install 4 high quality alkaline AA batteries (LR6). The green LED light will
flash three (3) times which indicates that the cat flap is in Automatic Mode.
3. To enter Learn Mode, press and hold the button in the battery
compartment until the red LED light appears (about 5 seconds). You will
have 60 seconds to position the cat's head in the tunnel to learn the
microchip ID. Once the cat flap has learned the microchip ID, it will unlatch
and the red LED will turn off. The cat flap will stay in Automatic Mode and
will re-latch after 3 seconds.
4. After successfully learning the cat's microchip ID, you will be ready to
install the cat flap into your door.
Note: To learn more than one cat, please follow the same steps starting with
step No. 3. The microchip cat flap can store up to 40 microchipped cats.
Replace the battery cover when the process is complete for all cats.
Helpful Tip: Program your cat's
microchip ID before installation to
prevent having to hold your cat in the
cat flap once it is installed. If you are
having trouble programming your cat's
microchip ID, please ensure that their
®
head is extended into the tunnel with the
microchip cat flap oriented as shown.
You should hear the cat flap unlatch once
it has learned your cat's microchip ID.
Note: If your cat's head touches the clear flap prior to
unlatching, then the microchip is not located for best use of
this product. Please contact PetSafe
additional options for operation.
Accessories available online
Customer Service for
®
3