Eldom perfect juicer PJ700 Gebrauchsanweisung Seite 13

Nuts milk
squeezing the "milk" out of soybeans, peanuts, almonds – soak the products for
approx. 8-12 hours, then place them in the juicer together with the water.
Salad
program for use with the shredding tip..
Washing
rinsing – block the juice flow and pour approx. 400 ml of water into the collector.
The appliance will only function if all parts have been properly assembled and only than the
microswitch will be unlocked.
- always operate the product on a flat, stable surface
- put the plug in the wall socket
- slice products into pieces which fit into the feeding tube that is in the lid (2).
Only soft fruit, e.g. apples or oranges can be inserted as a whole. The tunnel in the lid is equipped
with a special blade that cuts the inserted products, which should be lightly pressed. Inserting
hard fruit/vegetables, e.g. beetroot as a whole can damage the blade and the gears. This damage
is not covered by the warranty. If the frozen fruit filter is in use, do not mount the filter base in the
juice collector.
- make sure the juice jug (14) has been placed under the juice spout (8).
- make sure that pulp container (13) has been placed under the pulp spout (7)
- - turn the device on with the "POWER" button – the symbol of the selected program will be
displayed, other symbols will be highlighted,
- touch and hold the "MENU" button until the symbol of the desired program starts blinking,
- press "START" to start the juicer. To stop the juicer press "START" again
- the selected program will be active,
- to change the program, press the "POWER" button, and use the "MENU" button to select another
program,
- put prepared fruits/vegetables in the feeding tube and gently press them down towards
the rotating bolt by means of the pusher. Do not exert too much pressure on the pusher, as that
could affect the quality of the end result or evean blocked the appliance.
Never insert your fingers or an object into the feeding tube.
- The juice will flow directly in the juice jug (14), and the pulp will be collectedin the pulp container
(13). If necessary, repeat the process 2 or 3 times, then disable and dismantle PERFECT JUICER (see
the CLEANING section) so as to remove the jamming piece.
- After you have processed all ingredients and the juice flow has stopped, switch the appliance off
and wait until the filter has stopped rotating
- Make sure you observe the maximum time of continuous operation of the appliance. Exceeding
the time limit and failing to provide appropriate breaks during the operation of the appliance may
cause irreparable damage to the engine.
CLEANING
When device is not used or before cleaning, disconnect it from the network.
The appliance is easier to clean if you do so immediately after use. For this purpose, select the
"Washing" programDo not use abrasive cleaning agents, scourers, acetone, alcohol etc. to clean the
appliance. Place the detachable plastic parts on the top tray of the dishwasher. Make sure they are
placed well away from the heating element.
Switch the appliance off, remove the plug from the wall socket. Next dissassemble the appliance in
the following order:
- Remove the pushe (1)
13|EN