Installing The Camera; Wiring - Clarion CC520 Bedienungs- Und Installationshandbuch

Installing the camera

Option 1: Peel off double-sided tape backing from
bracket (A) and place camera in suitable location.
Adjust camera angle by using adjustment screw.
Option 2: Installing the camera with CAU001 /
CAU002 please use bracket B.
*CAU001 /CAU002 not included.
CAUTION
• When adjusting the camera
position, do not allow the camera
cable to be excessively stretched or
loose.
• Periodically check the tightness of
the installation screws and retighten
if necessary.

6. WIRING

1. Lead the camera cable into the vehicle and align it along the vehicle weather stripping.
Use cable holders as necessary to fix the wires in place to prevent from being pinched
in hinges or dampers.
2. Fix the cable with adequate looseness in this area to prevent it from being stretched or
pinched in the hinge when the rear gate is opened and closed.
6
CC520
White wire cable:
Mirror option
White Cable#1
White Cable#2
Green Cable#2
Green Cable#1
Green Cable:
Parking Line
Option 1:
Protective
paper
Mounting
bracket A
Option 2:
for CAU001 /CAU002
only
Bracket
from CAU001/
CAU002
Mounting
bracket B
Wiring Instructions:
The White wires that comes out of the side of the
harness are to control the Mirror Effect to the
image. Leave the two white wires disconnected if a
mirrored image is desired or connect them
together for a normal image.
The Green wires that comes out of the side of the
harness are to control the Parking Grid Lines
Option. Leave the green wires disconnected if the
parking grid lines should be viewed or connect
them together to remove gridlines from the image.
To Video Input
Connect to +12V
Switched Accessory
(Red Wire)
Connect to
Chassis Ground
(Black Wire)