Facom BCS.12-15 Bedienungsanleitung Seite 13

1. BATTERY TESTING
A - Check proper fastening of the battery lugs (lack of play).
B - Use a voltmeter to check that the voltage at the terminals
exceed 12V.
2. BUTTON TEST SWITCH (RED BUTTON ON FRONT PANEL)
A- Turn the switch until hearing a locking click.
3. CHECKING THE MALE / MALE CIGARETTE LIGHTER FUSES
A - Are the fuses of the male/male cigarette lighter plug still
operative? Otherwise change them.
4. BOOSTER MODE TEST
Set the switch to booster position; check the internal battery is connected and charged properly. Do not connect the device to 220V
mains.
A - Is the right lamp (counter graduation % picto) lit green?
B - Has a fault of the booster mode been found?
5. INTERNAL CHARGING MODE TEST
Set the switch to charging position; ensure the internal battery is connected and charged properly. Connect the device to 220V mains.
A - PRESS THE "BCS.12-15" BUTTON; the diodes then switch on
in sequence indicating that charging is in progress.
B - Has a fault been found in the charging mode?
6. EXTERNAL CHARGING MODE TEST
Set the switch to the charging position; connect the clamps to a 12V battery in good operating condition. Connect the device to 220V
mains.
A - PRESS THE "wet battery" BUTTON; the diodes then switch
on in sequence indicating that charging is in progress.
B - Has a fault been found in the external charging mode?
NU-BCS.12-15_0216.indd 15
CHECK BCS.12-15 STEP BY STEP - DIAGNOSTIC AID
YES
YES
YES
If a fault is detected on the Switch button, do not perform the tests below.
Contact your Facom Distributor or Dealer.
YES
YES
YES
YES
YES
YES
YES
If no fault is found; read the product's operating instructions thoroughly.
In case of doubt, call your Facom Representative.
NO Improper fastening may cause bad contact. A fault is indicated
when the red diode is lit on the level of the triangle.
NO (Note: 12.0V means 100% empty, over 12.84V means 100%
charged!). The red fault diode is lit if U<12V.
NO No click = fault.
NO
NO
NO If no fault is detected; go to the next test.
NO
NO If no fault is detected; go to the next test.
NO
NO
15
2/15/2016 9:01:00 AM