Troubleshooting; Storage; Disposal - Chicago Pneumatic CP 1230 Sicherheits- Und Betriebsanleitung

Safety and operating instructions
CP 1230 and CP 1240
A. Torque: CP 1230, 100-125 lbf.ft (135-170 Nm)
and CP 1240, 125-150 lbf.ft (170- 203Nm).
B. The cylinder seal must protrude approximately
1 ⁄ " (1.6 mm) before assembly of the back
16
head.
C. Torque: 125–150 lbf.ft (170-203Nm). Apply
Loctite® 242™(Loctite is a registered trademark
of Henkel Corporation. 242 is a trademark of
Henkel Corporation).
Torque: 65–75 lbf.ft (90–100 Nm).
D.
E. Torque, Muffler (not illustrated) 6–7lbf.ft
(8–10 Nm).
Assembled length of spring or bushing.
F.
Model
CP 1230
CP 1240

Troubleshooting

If the pneumatic machine does not start, has low
power or uneven performance, check the following
points.
20
www.CrowderSupply.com • Toll Free: 888-883-5144
Min-Max length
in. (mm)
2 1 ⁄ –2 3 ⁄ (54.0–55.6)
8 16
2 17 ⁄ –2 19 ⁄ (64.3–65.9)
32 32
CP 1210, CP 1230, CP 1240
♦ Check that the insertion tool being used has the
correct shank dimension.
♦ Check that the pneumatic machine is getting the
correct amount of lubricant. Too much lubrication
can cause starting problems, low power or
uneven performance.
♦ Check that the compressed air system supplies
the machine with sufficient air pressure to give
full power.
Check that the dimension and length of the air
♦
hose are according to the recommendations. See
"Installation".
♦ If there is a risk of freezing, check that the
machine's exhaust ports are not blocked.
♦ If the machine function is still not satisfactory after
this procedure, contact an authorised service
workshop.

Storage

> Clean the machine properly before storage, in
order to avoid hazard substances. See "Dust and
fume hazard"
> Pour approximately 1 ⁄
2
the air inlet nipple, connect the machine to the
compressed air supply and start it for a few
seconds.
> Always store the machine in a dry place.

Disposal

A used machine must be treated and disposed of in
such a way that the greatest possible portion of the
material can be recycled and any negative influence
on the environment is kept as low as possible, and
in respect to local restrictions.
9800 0608 90d | Original instructions
oz (5 cl) of oil directly into